Related papers: Microwave programmable response of Co-based microw…
At millimeter wave (mmWave) frequencies, the higher cost and power consumption of hardware components in multiple-input multiple output (MIMO) systems do not allow beamforming entirely at the baseband with a separate radio frequency (RF)…
Magnetic-field and microwave-frequency modulated DNP experiments have been shown to yield improved enhancements over conventional DNP techniques, and even to shorten polarization build-up times. The resulting increase in signal-to-noise…
Wireless receiver design is critical to the overall system performance. In this work, we apply the techniques of mixed-integer programming to formulate a unified receiver in relay networks with only partial channel information. We also…
In pursuance of the unused spectrum in higher frequencies, millimeter wave (mmWave) bands have a pivotal role. However, the high path-loss and poor scattering associated with mmWave communications highlight the necessity of employing…
Polarforming emerges as a promising technique for manipulating the polarization of electromagnetic (EM) waves by shaping the polarization of an antenna into a desired state. By dynamically adjusting antenna polarization, polarforming…
Flexible-antenna systems have recently received significant research interest due to their capability to reconfigure wireless channels intelligently. This paper focuses on a new type of flexible-antenna technology, termed pinching antennas,…
In this paper, we consider the task of introducing a new wireless data link over a given occupied frequency band using a multi-antenna transmitter and receiver. We design formally a dynamic multiple-input multiple-output (MIMO) wireless…
This paper shows that customised broadband absorption of electromagnetic waves having arbitrary polarisation is possible by use of lossy cut-wire (CW) metamaterials. These useful features are confirmed by numerical simulations in which…
Densifying networks and deploying more antennas at each access point are two principal ways to boost the capacity of wireless networks. However, the complicated distributions of the signal power and the accumulated interference power,…
In this paper, adaptive hybrid beamforming methods are proposed for millimeter-wave range massive multiple-input-multiple-output (MIMO) systems considering single carrier wideband transmission in uplink data mode. A statistical analog…
We have investigated the microwave properties of epoxy-based composites containing melt-extracted Co69.25Fe4. 25B13.5-xSi13Nbx (x=0, 1, 3) microwires of various length annealed using a so-called combined current-modulation annealing (CCMA)…
Multiple-input multiple-output (MIMO) communication has led to immense enhancements in data rates and efficient spectrum management. The evolution of MIMO, though, has been accompanied by increased hardware complexity and array sizes,…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
To increase the power level and energy utilization rate of injection-locked magnetron sources, a dual way 1-kW S-band magnetron microwave power combining system with high combining efficiency was proposed and validated. A waveguide…
The objective of this research is to mitigate vibrations in induction motors. To achieve this goal, a discontinuous pulse width modulation (PWM) control strategy based on carrier wave modulation is proposed for multilevel inverters. This…
Microwave photonic (MWP) filters are essential components in microwave systems due to their wide bandwidth, low loss, and immunity to electromagnetic interference. A sharp transition band is critical for precise spectral shaping and…
The idea of media-based modulation (MBM) is to embed information in the channel states via intentional perturbations of the transmission media. This article covers a broad range of topics regarding MBM, expanding on its benefits and…
Magnetic remote actuation of soft materials is attractive for applications such as transforming materials and medical robots. However, due to manufacturing limitations, microscale magnetoactive devices are scarce -- light-based additive…
This work proposes a novel joint design for multiuser multiple-input multiple-output wiretap channels. The base station exploits a switching network to connect a subset of its antennas to the available radio frequency chains. The switching…
Future wireless networks, deploying thousands of antenna elements, may operate in the radiative near-field (NF), enabling spatial multiplexing across both angle and range domains. Sparse arrays have the potential to achieve comparable…