Related papers: Intensity Noise Optimization of a Mid-Infrared Fre…
We observe an interference pattern using a simple fiber-optic interferometer consisting of an electrical spectrum analyzer and a narrowband light source, which is commonly employed for observing the Brillouin gain spectrum. This…
It is well known that temperature variations and acoustic noise affect ultrastable frequency dissemination along optical fiber. Active stabilization techniques are in general adopted to compensate for the fiber-induced phase noise. However,…
In multisensor systems, time synchronization is particularly challenging for underwater integrated navigation systems (INSs) incorporating acoustic positioning, where time delays can significantly degrade accuracy when measurement and…
Interband Cascade Lasers (ICLs) are semiconductor lasers emitting in the mid-wave infrared (MWIR 3-6 {\mu}m) and can operate as frequency combs (FCs). These demonstrations are based on double section cavities that can reduce dispersion…
Heterodyne laser phase measurements in a space-based gravitational wave interferometer are degraded by the phase fluctuations of the onboard clocks, resulting in unacceptable sensitivity performance levels of the interferometric data. In…
We report what we believe to be the lowest phase noise optical-to-microwave frequency division using fiber-based femtosecond optical frequency combs: a residual phase noise of -120dBc/Hz at 1 Hz offset from a 11.55GHz carrier frequency. We…
We demonstrate that the sensitivity of high-precision pulsar timing experiments will be ultimately limited by the broadband intensity modulation that is intrinsic to the pulsar's stochastic radio signal. That is, as the peak flux of the…
Multiband sensing is a promising technology that utilizes multiple non-contiguous frequency bands to achieve high-resolution target sensing. In this paper, we investigate the fundamental limits and optimization of multiband sensing,…
The medium-long term frequency stability of the integrating sphere cold atom clock was improved.During the clock operation, Rb atoms were cooled and manipulated using cooling light diffusely reflected by the inner surface of a microwave…
A facility for sub-nanosecond time-resolved (pump-probe) infrared spectroscopy has been developed at the National Synchrotron Light Source of Brookhaven National Laboratory. A mode-locked Ti:sapphire laser produces 2 ps duration, tunable…
While mid-infrared optical frequency combs have been widely utilized in areas such as trace gas sensing, chemical kinetics, and combustion science, the relatively low power per comb tooth has limited acquisition times and sensitivities. We…
An accurate delay and Doppler estimation method for a radar system using time and frequency-shifted pulses with pseudo-random numbers is proposed. The ambiguity function of the transmitted signal has a strong peak at the origin and is close…
The strong correlation between energy injection and mid-infrared (mid-IR) emission observed during solar flares can be used to probe energy deposition throughout the chromosphere, since the IR tracks prompt flare-induced changes in electron…
This paper shows the experimental details of the stabilization scheme that allows full control of the repetition rate and the carrier-envelope offset frequency of a 10 GHz frequency comb based on a femtosecond Ti:sapphire laser.…
We numerically study the mechanisms of frequency comb generation in the mid-infrared spectral region from cw pumped silicon microring resonators. Coherent soliton comb generation may be obtained even for a pump with zero linear cavity…
We have built a frequency chain which enables to measure the absolute frequency of a laser emitting in the 28-31 THz frequency range and stabilized onto a molecular absorption line. The set-up uses an optical frequency comb and an…
Time-varying metamaterials rely on large and fast changes of the linear permittivity. Beyond the linear terms, however, the effect of a non-perturbative modulation of the medium on harmonic generation and the associated nonlinear…
The potential of frequency comb spectroscopy has aroused great interest in generating mid-infrared frequency combs in the integrated photonic setting. However, despite remarkable progress in microresonators and quantum cascade lasers, the…
We demonstrate an optical frequency comb based on an erbium-doped-fiber femtosecond laser with the nonlinear polarization evolution scheme. The repetition rate of the laser is about 209 MHz. By controlling an intra-cavity electro-optic…
The repetition rate stabilization of an optical frequency comb based on diode-pumped solid-state laser technology is demonstrated using an intra-cavity electro-optic modulator. The large feedback bandwidth of such modulators allows…