Related papers: Simple Design on Nanoscale Receivers Using CNT Can…

The capabilities of the mechanical resonator-based nanosensors in detecting ultra-small mass or force shifts have driven a continuing exploration of the palette of nanomaterials for such application purpose. Based on large-scale molecular…

We demonstrate the procedure of Scanning Probe Microscopy (SPM) conductive probe fabrication with a single multi-walled carbon nanotube (MWNT) on a silicon cantilever pyramid. The nanotube bundle reliably attached to the metal-covered…

A new DC thermal model of Carbon Nanotube Field Effect Transistors (CNTFETs) is proposed. The model is based on a number of fitting parameters depending on bias conditions by third order polynomials. The model includes three thermal…

With decreasing device dimensions, the performance of carbon nanotube field-effect transistors (CNFETs) is limited by high Off currents except at low drain voltages. We show that an asymmetric design improves the performance, reducing Off…

Carbon based optoelectronic devices promise to revolutionize modern integrated circuits by combining outstanding electrical and optical properties into a unified technology. By coupling nanoelectronic devices to nanophotonic structures…

Macroscopic fibers of carbon nanotubes (CNT) have emerged as an ideal architecture to exploit the exceptional properties of CNT building blocks in applications ranging from energy storage to reinforcement in structural composites.…

Integrated chemical and biological sensors give advantages in cost, size and weight reduction and open new prospects for parallel monitoring and analysis. Biosensors based on nanoelectromechanical systems (NEMS) are the most attractive…

In optical detection setups to measure the deflection of micro-cantilevers, part of the sensing light is absorbed, heating the mechanical probe. We present experimental evidences of a frequency shift of the resonant modes of a cantilever…

We investigate the coupling of a nanomechanical oscillator in the quantum regime with molecular (electric) dipoles. We find theoretically that the cantilever can produce single-mode squeezing of the center-of-mass motion of an isolated…

A model of carrier phase measurement (as carried out by a satellite navigation receiver) is formulated based on electromagnetic theory. The model shows that the phase of the open-circuit voltage induced in the receiver antenna with respect…

Single wall carbon nanotubes cooled to cryogenic temperatures are outstanding electronic as well as nano-electromechanical model systems. To probe a largely unperturbed system, we measure a suspended carbon-nanotube device where the…

In this paper, we propose a novel splitting receiver, which involves joint processing of coherently and non-coherently received signals. Using a passive RF power splitter, the received signal at each receiver antenna is split into two…

Coupling carbon nanotube devices to microwave circuits offers a significant increase in bandwidth and signal-to-noise ratio. These facilitate fast non-invasive readouts important for quantum information processing, shot noise and…

We present a general approach to the computational design of nanostructured chemical sensors. The scheme is based on identification and calculation of microscopic descriptors (design parameters) which are used as input to a thermodynamic…

Advanced electronic device technologies require a faster operation and smaller average power consumption, which are the most important parameters in very large scale integrated circuit design. The conventional Complementary Metal-Oxide…

In quantum illumination (QI) the non-classical correlations between continuous variable (CV) entangled modes of radiation are exploited to detect the presence of a target embedded in thermal noise. The extreme environment where QI…

We demonstrate a "bottom up" approach to the computational design of a multifunctional chemical sensor. General techniques are employed for describing the adsorption coverage and resistance properties of the sensor based on density…

The development of lightweight flex PCBs and nanowire-based thermal interfaces for low-mass, high-performance detector modules are presented. A novel manufacturing approach targeting flex circuits with double-sided pad access, assembled…

Junctionless transistors made of silicon have previously been demonstrated experimentally and by simulations. Junctionless devices do not require fabricating an abrupt source-drain junction and thus can be easier to implement in aggressive…

Aligning a microcantilever to an area of interest on a sample is a critical step in many scanning probe microscopy experiments, particularly those carried out on devices and rare, precious samples. We report a series of protocols that…