Related papers: An Alternating Direction Algorithm for Hybrid Prec…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
Hybrid precoding is a promising technique for mmWave massive MIMO systems, as it can considerably reduce the number of required radio-frequency (RF) chains without obvious performance loss. However, most of the existing hybrid precoding…
The deployment of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems cannot rely solely on digital precoding due to hardware constraints. Instead, hybrid precoding, which combines digital and radio frequency (RF)…
In this article, we investigate channel estimation for wideband millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) under hybrid architecture with lowprecision analog-to-digital converters (ADCs). To design channel…
Millimeter wave (mmWave) is a practical solution to provide high data rate for the vehicle-to-everything (V2X) communications. This enables the future autonomous vehicles to exchange big data with the base stations (BSs) such as the…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
Configuring the hybrid precoders and combiners in a millimeter wave (mmWave) multiuser (MU) multiple-input multiple-output (MIMO) system is challenging in frequency selective channels. In this paper, we develop a system that uses…
Hybrid analog-digital (A/D) transceivers designed for millimeter wave (mmWave) systems have received substantial research attention, as a benefit of their lower cost and modest energy consumption compared to their fully-digital…
This paper studies energy-efficient hybrid beamforming architectures and its algorithm design in millimeter-wave communication systems, aiming to address the challenges faced by existing hybrid beamforming due to low hardware flexibility…
Hybrid analog and digital precoding allows millimeter wave (mmWave) systems to achieve both array and multiplexing gain. The design of the hybrid precoders and combiners, though, is usually based on knowledge of the channel. Prior work on…
Hybrid precoding is a cost-effective approach to support directional transmissions for millimeter-wave (mm-wave) communications, but its precoder design is highly complicated. In this paper, we propose a new hybrid precoder implementation,…
The potential of using millimeter-wave (mmWave) to encounter the current bandwidth shortage has motivated packing more antenna elements in the same physical size which permits the advent of massive multiple-input-multiple-output (MIMO) for…
Hybrid analog/digital precoding is a promising technology to cut down hardware cost in massive multi-input multi-output (MIMO) systems at millimeter wave frequencies. In this letter, we propose a joint beam selection scheme for analog…
In this paper, we propose a novel joint hybrid precoder and combiner design for maximizing the average achievable sum-rate of single-user orthogonal frequency division multiplexing millimeter wave massive MIMO systems. We formulate the…
To enable user diversity and multiplexing gains, a fully digital precoding multiple input multiple output (MIMO) architecture is typically applied. However, a large number of radio frequency (RF) chains make the system unrealistic to…
In this paper, we propose a feedback-efficient hybrid precoding framework for wideband millimeter-wave (mmWave) multiple-input multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) systems. To mitigate the high cost of…
Hybrid precoding design can be challenging for broadband millimeter-wave (mmWave) massive MIMO due to the frequency-flat analog precoder in radio frequency (RF). Prior broadband hybrid precoding work usually focuses on fully-connected array…
In this paper, we propose a new hybrid analog and digital combining architecture for millimeter wave (mmWave) multi-user multiple-input multiple-output (MU-MIMO) systems. The proposed structure employs antenna subset selection per radio…
Millimeter wave (mmWave) multi-user massive multi-input multi-output (MIMO) is a promising technique for the next generation communication systems. However, the hardware cost and power consumption grow significantly as the number of radio…
Millimeter wave (mmWave) communications have been considered as a key technology for future 5G wireless networks. In order to overcome the severe propagation loss of mmWave channel, mmWave multiple-input multiple-output (MIMO) systems with…