Related papers: Non-Uniform Suction Control of Flow around a Circu…
We carried out high-resolution large-eddy simulations (LESs) to investigate the effects of several separation-control approaches on a NACA4412 wing section with spanwise width of $L_z = 0.6$ at an angle of attack of $AoA=11^{\circ}$ at a…
In this letter, a physics-based data-driven strategy is developed to predict vortex-induced drag on a circular cylinder under non-uniform inflow conditions - a prevalent issue for engineering applications at moderate Reynolds numbers.…
A model for the development of turbulent shear flows, created by non-uniform parallel flows in a confining channel, is used to identify the diffuser shape that maximises pressure recovery when the inflow is non-uniform. Wide diffuser angles…
The application of drag-control strategies on canonical wall-bounded turbulence, such as periodic channel and zero- or adverse-pressure-gradient boundary layers, raises the question of how to describe control effects consistently for…
Control surface deployment in a supersonic flow has many applications, including flow control, mixing, and body-force regulation. The extent of control surface deflections introduces varying flow unsteadiness. The resulting fluid dynamics…
The paper presents a high Reynolds number experimental study of turbulent boundary layer separation control on a convex plate using the wavy-wall method, which was initially proposed for a flat plate by Dr\'o\.zd\.z et al. 2021 (Exp Therm…
The classical problem of suppressing vortex shedding in the wake of a circular cylinder by using body rotation is revisited in an adjoint-based optimal control framework. The cylinder's unsteady and fully unconstrained rotation rate is…
The flow past a fixed finite-length circular cylinder, the axis of which makes a nonzero angle with the incoming stream, is studied through fully-resolved simulations, from creeping-flow conditions to strongly inertial regimes. The…
This study computes the optimal normal actuation on the surface of a NACA0012 airfoil at an angle of attack of 15{\deg} and a Reynolds number of Re = 1000, using costs defined for minimal drag and maximal lift. To allow for a general…
We propose a data-driven methodology to learn a low-dimensional manifold of controlled flows. The starting point is resolving snapshot flow data for a representative ensemble of actuations. Key enablers for the actuation manifold are…
We study the separating flow over a circular cylinder with two objectives: (i) to demonstrate the validity of the condition of matching curvature, and (ii) to obtain a reasonable estimate of the separation angle in the subcritical regime…
The optimal control of a globally unstable two-dimensional separated boundary layer over a bump is considered using augmented Lagrangian optimization procedures. The present strategy allows of controlling the flow from a fully developed…
A variational technique is used to derive analytical expressions for the sensitivity of recirculation length to steady forcing in separated flows. Linear sensitivity analysis is applied to the two-dimensional steady flow past a circular…
Opposition-control of the energetic cycle of near wall streaks in wall-bounded turbulence, using numerical approaches, has shown promise for drag reduction. For practical implementation, opposition control is only realizable if there is a…
We numerically simulate turbulent Taylor-Couette flow for independently rotating inner and outer cylinders, focusing on the analogy with turbulent Rayleigh-B\'enard flow. Reynolds numbers of $Re_i=8\cdot10^3$ and $Re_o=\pm4\cdot10^3$ of the…
Linear optimal gains are computed for the subcritical two-dimensional separated boundary-layer flow past a bump. Very large optimal gain values are found, making it possible for small-amplitude noise to be strongly amplified and to…
Rotor-stator flows are known to exhibit instabilities in the form of circular and spiral rolls. While the spirals are known to emanate from a supercritical Hopf bifurcation, the origin of the circular rolls is still unclear. In the present…
Turbulent flow past an equilateral triangular cylinder with splitter plate inserted downstream is numerically tested for different gap ratios (0, 0.5, 1, 1.5, 2) and plate dimensions (0, 1, 1.5) on the flow field and heat transfer…
In this work the numerical stability of a streamline singular hyperbolic/saddle critical point (HSP) and its relationship with the divergence of pressure force/fluid flux are numerically investigated at low Reynolds numbers. Three canonical…
A canonical problem of axially strained flow in a duct of circular-sector cross-section, with fluid injection through the circular arc, is examined for a range of Reynolds numbers and sector angles. At small Reynolds numbers, the flow…