Related papers: A Two-Dimensional Resistor Network Model for Trans…
Transition Metal Dichalcogenides (TMD) are layered materials obtained by stacking two-dimensional sheets weakly bonded by van der Waals interactions. In bulk TMD, band dispersions are observed in the direction normal to the sheet plane…
The scope of this article is to review the state-of-the-art in the field of confined electron systems generated at the bare surfaces of transition metal oxides (TMOs). This scientific field is a prime example of a domain where…
Transition edge sensor (TES) microcalorimeters and bolometers are used for a variety of applications. The sensors are based on the steep temperature-dependent resistance of the normal-to-superconducting transition, and are thus…
This article explores the recent advancements in atomically thin two-dimensional transition metal dichalcogenides (2D TMDs) and their potential applications in various fields, including nanoelectronics, photonics, sensing, energy storage,…
Feature sizes in integrated circuits have decreased substantially over time, and it has become increasingly difficult to three-dimensionally image these complex circuits after fabrication. This can be important for process development,…
Topological materials host fascinating low dimensional gapless states at the boundary. As a prominent example, helical topological edge states (TESs) of two-dimensional topological insulators (2DTIs) and their stacked three-dimensional (3D)…
At low temperatures, < 200 mK, the thermal flux through low-dimensional amorphous dielectric bars, < 2 $\mu$m wide and 200 nm thick, is transported by a small number of low-order elastic modes. For long bars, L > 400 $\mu$m, it is known…
We report initial measurements on our firstMoAu Transition Edge Sensors (TESs). The TESs formed from a bilayer of 40 nm of Mo and 106 nm of Au showed transition temperatures of about 320 mK, higher than identical TESs with a MoCu bilayer…
An exact solution for electromagnetic wave diffraction at the junction of two-dimensional electron systems (2DES) is obtained and analyzed for electric field polarized along the edge. A special emphasis is paid to the metal-contacted and…
Experimental searches for axions or dark photons that couple to the standard model photon require photosensors with low noise, broadband sensitivity, and near zero backgrounds. Here, we introduce an experimental architecture, in which a…
We report a new strategy for fabricating 2D/2D low-resistance ohmic contacts for a variety of transition metal dichalcogenides (TMDs) using van der Waals assembly of substitutionally doped TMDs as drain/source contacts and TMDs with no…
Generation of photocurrent via photon drag effect enables very fast light detection with response time limited by momentum relaxation. At the same time, photon drag in bulk uniform samples is small by the virtue of small photon momentum. We…
Two-dimensional (2D) transition metal dichalcogenide (TMD) materials have versatile electronic and optical properties. TMD nanoribbons show interesting properties due to reduced dimensionality, quantum confinement, and edge states. Tang et…
Experiments deploying large arrays of transition-edge sensors (TESs) often require a robust method to monitor gain variations with minimal loss of observing time. We propose a sensitive and non-intrusive method for monitoring variations in…
The next generation of Far-infrared and X-ray space observatories will require detector arrays with thousands of transition edge sensor (TES) pixel. It is extremely important to have a tool that is able to characterize all the pixels and…
Transition metal dichalcogenides (TMDs) are layered semiconducting van der Waal crystals and promising materials for a wide range of electronic and optoelectronic devices. Realizing practical electrical and optoelectronic device…
Our previous molecular dynamic simulation studies of simple two-dimensional (2D) systems \cite{matt_big} suggested that both geometrical defects (localized, large-amplitude deviations from hexagonal ordering) and topological defects…
We study the resistivity of three-dimensional semimetals with linear dispersion in the presence of on-site electron-electron interaction. The well-known quadratic temperature dependence of the resistivity of conventional metals is turned…
Understanding the relationship between atomic structure (order) and chemical composition (chemistry) is critical for advancing materials science, yet traditional spectroscopic techniques can be slow and damaging to sensitive samples.…
Using first-principles atomistic simulations, we study the response of atomically-thin layers of transition metal dichalcogenides (TMDs) - a new class of two-dimensional inorganic materials with unique electronic properties - to electron…