Related papers: Spatio-Temporal Waveform Design in Active Sensing …
Beamforming design has been widely investigated for integrated sensing and communication (ISAC) systems with full-duplex (FD) sensing and half-duplex (HD) communication. To achieve higher spectral efficiency, in this paper, we extend…
Dual-functional radar-communication (DFRC) has attracted considerable attention. This paper considers the frequency-selective multipath fading environment and proposes DFRC waveform design schemes based on multiple-input and multiple-output…
In this paper, we consider a three-node cooperative wireless powered communication system consisting of a multi-antenna hybrid access point (H-AP) and a single-antenna relay and a single-antenna user. The energy constrained relay and user…
Automotive radar is a key component in an ADAS. The increasing number of radars implemented in vehicles makes interference between them a noteworthy issue. One method of interference mitigation is to limit the TBP of radar waveforms.…
This paper investigates the optimal transmit beamforming design of simultaneous wireless information and power transfer (SWIPT) in the multiuser multiple-input-single-output (MISO) downlink with specific absorption rate (SAR) constraints.…
Wirelessly powered backscatter communication (WPBC) has been identified as a promising technology for low-power communication systems, which can reap the benefits of energy beamforming to improve energy transfer efficiency. Existing studies…
Controlling systems governed by partial differential equations is an inherently hard problem. Specifically, control of wave dynamics is challenging due to additional physical constraints and intrinsic properties of wave phenomena such as…
In the low-altitude wireless networks, the simultaneous sensing data acquisition and sharing (SDAS) through an ISAC signaling strategy becomes a typical application scenario. In this paper, we mainly investigate three primary aspects of the…
This paper studies the transmit energy beamforming in a multi-antenna wireless power transfer (WPT) system, in which an access point (AP) equipped with a uniform linear array (ULA) sends radio signals to wirelessly charge multiple…
Wireless communication environments comprise passive objects that cause performance degradation and eavesdropping concerns due to anomalous scattering. This paper proposes a new paradigm, where scattering becomes software-defined and,…
Integrated sensing and communication (ISAC) systems potentially encounter significant performance degradation in densely obstructed urban and non-line-of-sight scenarios, thus limiting their effectiveness in practical deployments. To deal…
The utilization of RF signals to probe material properties of objects is of huge interest both in academia as well as industry. To this end, a setup is investigated, in which a transmitter equipped with a two-dimensional multi-antenna array…
In this paper, we study resource allocation algorithm design for power efficient secure communication with simultaneous wireless information and power transfer (WIPT) in multiuser communication systems. In particular, we focus on power…
Multiple scattering of waves in complex media can be harnessed and tailored for diverse phenomena in sound and light. Despite the tremendous progress enabled by technologies such as time-reversal propagation and wavefront shaping, the full…
Dual-function radar-communication (DFRC) systems offer high spectral, hardware and power efficiency, as such are prime candidates for 6G wireless systems. DFRC systems use the same waveform for simultaneously probing the surroundings and…
As a next-generation wireless technology, the in-band full-duplex (IBFD) transmission enables simultaneous transmission and reception of signals over the same frequency, thereby doubling spectral efficiency. Further, a continuous up-scaling…
This paper considers downlink multicast transmit beamforming for secure layered transmission systems with wireless simultaneous information and power transfer. We study the power allocation algorithm design for minimizing the total transmit…
Elastic wave propagation is studied in a heterogeneous 2-D medium consisting of an elastic matrix containing randomly distributed circular elastic inclusions. The aim of this study is to determine the effective wavenumbers when the incident…
Doppler reflectometry spatial and wavenumber resolution is analyzed within the framework of the linear Born approximation in slab plasma model. Explicit expression for its signal backscattering spectrum is obtained in terms of wavenumber…
Waveform design is a key technique to jointly exploit a beamforming gain, the channel frequency-selectivity and the rectifier nonlinearity, so as to enhance the end-to-end power transfer efficiency of Wireless Power Transfer (WPT). Those…