Related papers: Hybrid Beamforming: Where Should the Analog Power …
Recently, full duplex (FD) has been studied in 5G LTE millimeter wave (mmWave) cellular communications for New Radio in 3GPP releases 15-17. FD allows bidirectional transmission over the same resources and has the potential to reduce…
Enhancing high-speed wireless communication in the future relies significantly on harnessing high frequency bands effectively. These bands predominantly operate in line-of-sight (LoS) paths, necessitating well-configured antenna arrays and…
Hybrid multiple-input multiple-output (MIMO) is an attractive technology for realizing extreme massive MIMO systems envisioned for future wireless communications in a scalable and power-efficient manner. However, the fact that hybrid MIMO…
This study investigates subarray-level movable antenna (MA) architecture for multi-user MIMO (MU-MIMO) systems. Unlike conventional systems with fixed-position antennas (FPAs), the proposed scheme harnesses the additional positional degrees…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
Hybrid beamforming (HBF) and antenna selection are promising techniques for improving the energy efficiency~(EE) of massive multiple-input multiple-output~(mMIMO) systems. However, the transmitter architecture may contain several parameters…
This paper investigates a new analog beamforming architecture for massive multiple-input multiple-output (MIMO) systems, where each of the multiple transmit antennas is switched to be on or off to form a beam according to the channel state…
The joint transmit and pinching beamforming design for spectral efficiency (SE) and energy efficiency (EE) tradeoff in pinching-antenna systems (PASS) is proposed, under practical channel and energy consumption models. In the single-user…
Hybrid analog and digital beamforming is a promising candidate for large-scale mmWave MIMO systems because of its ability to significantly reduce the hardware complexity of the conventional fully-digital beamforming schemes while being…
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array…
Hybrid beamforming for frequency-selective channels is a challenging problem as the phase shifters provide the same phase shift to all of the subcarriers. The existing approaches solely rely on the channel's frequency response and the…
The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…
This paper proposed new hybrid, analog-digital, beamforming for a multiuser millimeter wave (mm-wave) relay system. For this system, we consider a sum rate maximization problem. The proposed hybrid beamforming is designed indirectly by…
Future cellular systems based on the use of millimeter waves will heavily rely on the use of antenna arrays both at the transmitter and at the receiver. For complexity reasons and energy consumption issues, fully digital precoding and…
Multiple-input multiple-output (MIMO) systems exploit spatial diversity to facilitate multi-user communications with high spectral efficiency by beamforming. As MIMO systems utilize multiple antennas and radio frequency (RF) chains, they…
We investigate full-duplex (FD) multi-user multiple input single-output systems with coarse quantization, aiming to characterize the impact of employing low-resolution analog-to-digital converters (ADCs) on self-interference (SI) and to…
This letter considers the architecture of distributed antenna system, which is made up of a massive number of single-antenna remote radio heads (RRHs), some with full-resolution but others with low-resolution analog-to-digital converter…
A near-field wideband communication system is investigated in which a base station (BS) employs an extra-large scale antenna array (ELAA) to serve multiple users in its near-field region. To facilitate near-field multi-user beamforming and…
Massive multiple-input multiple-output (MIMO) relaying is a promising technological paradigm which can offer high spectral efficiency and substantially improved coverage. Yet, these configurations face some formidable challenges in terms of…
In this paper, we aim to design highly energy efficient end-to-end communication for millimeter wave multiple-input multiple-output systems. This is done by jointly optimizing the digital-to-analog converter (DAC)/analog-to-digital…