Related papers: Tailoring the crack-tip microstructure: A novel ap…
Iron-oxide nanoflowers (NFs) are one of the most efficient nanoheaters for magnetic hyperthermia therapy (MHT). However, the physics underlying the spin texture of disordered iron-oxide nanoparticles beyond the single-domain limit remains…
Quasi-brittle materials endowed with (statistically) self-similar hierarcical microstructures show distinct failure patterns that deviate from the standard scenario of damage accumulation followed by crack nucleation-and-growth. Here we…
Molecular dynamics simulations were used to quantify mechanically-induced structural evolution in nanocrystalline Al with an average grain size of 5 nm. A polycrystalline sample was cyclically strained at different temperatures, while a…
We have produced solution-processed thin films of 6,13-bis(triisopropyl-silylethynyl) pentacene with grain sizes from a few micrometers up to millimeter scale by lateral crystallization from a rectangular stylus. Grains are oriented along…
Chromium substituted cobalt ferrite with grain size less than the single domain (approx. 70 nm) has been prepared by the sol-gel method. XRD analysis reveals that the samples crystallize to cubic symmetry with spacegroup number 227. Two…
Strain tuning is increasingly being recognized as a clean tuning parameter to induce novel behavior in quantum matter. Motivated by the possibility of straining graphene up to $20$ percent, we investigate novel quantum criticality due to…
We report structural, magnetic and dielectric properties of Co1.5Fe1.5O4 nanoparticles and their composites with non-magnetic NaNO3. The samples were derived from metal nitrates solution at different pH values. The chemical routed sample…
A finite element framework is presented for analyzing crack-tip phenomena in transversely isotropic, strain-limiting elastic materials. Mechanical response is characterized by an algebraically nonlinear constitutive model, relating stress…
A 10 wt.% nickel-steel has been developed for high pressures and low-temperature applications, due to its high strength, excellent toughness, and low ductile-to-brittle transition temperature (DBTT). Under dynamic loading conditions this…
Ferroelectric domain switching in c-axis-oriented epitaxial Pb(Zr$_{0.2}$Ti$_{0.8}$)O$_3$ thin films was studied using biased scanning probe microscopy tips. While linear and logarithmic dependence of domain size on tip bias and writing…
Nanoparticles of Cr3+-substituted Ni-Zn ferrites with a general formula Ni0.4Zn0.6-xCrxFe2O4 (x = 0.0 - 0.6) have been synthesized via a facile microwave combustion route. The crystalline phase has been characterized by XRD, TEM, FT-I and…
The direct experimental probing of locally varying lattice parameters and anisotropic lattice deformations in atomic multilayers is extremely challenging. Here, we develop a new combined numerical/graphical method for the analysis of…
Cobalt ferrite nanoparticles have been synthesized using a co-precipitation approach. Co:Fe precursor ratio is varied over a certain window (1.05 to 1.2). It is observed that the 1.15:2 precursor ratio gives better phase control but poor…
The Dirac nodal-line semimetals (DNLS) are new promising materials for technological applications due to its exotic properties, which originate from band structures dispersion and nodal-line behavior. We report a study on effects of several…
We have analysed the influence of the microstructural features, such as intergranular grain boundary (GB) phases and misalignment of the hard magnetic grains, on the optimization of magnetization reversal processes in order to improve the…
The buckling of graphene nano-ribbons containing a grain boundary is studied using atomistic simulations where free and supported boundary conditions are invoked. We found that when graphene contains a small angle grain boundary the…
Predicting the mechanical failure of parts in service requires understanding their deformation behavior, and associated dynamic microstructural evolution up to the near-atomic scale. Solutes are known to interact with defects generated by…
Yb-substituted Ni-Zn ferrites have been synthesized using sol-gel auto combustion method. The structural characterization of the compositions has been performed by X-ray diffraction analysis, field emission scanning electron microscopy…
Grain growth is a key process in the thermomechanical treatment of metals. Recently, the presence of local residual stresses within fully recrystallized grains has attracted increasing interest in connection with shear-coupled grain…
We study numerically and analytically the coarsening of stripe phases in two spatial dimensions, and show that transient configurations do not achieve long ranged orientational order but rather evolve into glassy configurations with very…