Related papers: Lower Bound on the Sum-rate of Decremental Beam Se…
In this letter, we consider linear precoding for downlink massive multi-user (MU) multiple-input multiple-output (MIMO) systems. We propose the novel successively-regularized zero forcing (SRZF) precoding, which exploits successive null…
This paper studies a downlink multi-user multiple-input multiple-output (MU-MIMO) system, where the precoding matrix is computed at a baseband unit (BBU) and then transmitted to the remote antenna array over a limited-capacity digital…
MIMO systems in the lower part of the millimeter-wave spectrum band (i.e., below 28 GHz) do not exhibit enough directivity and selectively, as their counterparts in higher bands of the spectrum (i.e., above 60 GHz), and thus still suffer…
The deployment of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems cannot rely solely on digital precoding due to hardware constraints. Instead, hybrid precoding, which combines digital and radio frequency (RF)…
In this paper, a combination of Space Time Block Coded Spatial Modulation with Hybrid Analog-Digital Beamforming (STBC-SM-HBF) for Millimeter-wave (mmWave) communications is proposed in order to take advantage of the merits of Spatial…
This paper investigates the linear precoder design for $K$-user interference channels of multiple-input multiple-output (MIMO) transceivers under finite alphabet inputs. We first obtain general explicit expressions of the achievable rate…
This paper investigates the achievable sum-rate of massive multiple-input multiple-output (MIMO) systems in the presence of channel aging. For the uplink, by assuming that the base station (BS) deploys maximum ratio combining (MRC) or…
In future practical deployments of massive multi-input multi-output (MIMO) systems, the number of radio frequency (RF) chains at the base stations (BSs) may be much smaller than the number of BS antennas to reduce the overall expenditure.…
This paper proposes the joint design of reconfigurable intelligent surfaces (RIS) and zero-forcing (ZF) precoding for the downlink (DL) multiuser multiple-input single-output (MU-MISO) setup in millimeter-wave (mmWave) bands, where ZF is…
Deploying massive number of antennas at the base station side can boost the cellular system performance dramatically. Meanwhile, it however involves significant additional radio-frequency (RF) front-end complexity, hardware cost and power…
The application of hybrid precoding in millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems has been proved effective for reducing the number of radio frequency (RF) chains. However, the maximum number of independent data…
Using precoding to suppress multi-user interference is a well-known technique to improve spectra efficiency in multiuser multiple-input multiple-output (MU-MIMO) systems, and the pursuit of high performance and low complexity precoding…
This paper revisits linear precoding, namely match-filter (MF) and zero-forcing (ZF), in a semantic multiple-input multiple-output (MIMO) system empowered by generative AI. The aim is to examine whether interference, channel state…
Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…
Hybrid analog/digital precoding offers a compromise between hardware complexity and system performance in millimeter wave (mmWave) systems. This type of precoding allows mmWave systems to leverage large antenna array gains that are…
Spatial multiplexing (SMX) multiple-input multiple-output (MIMO) over the best beamspace was considered as the best solution for millimeter wave (mmWave) communications regarding spectral efficiency (SE), referred as the best beamspace…
In this paper, we study the performance of cooperative millimeter wave (mmWave) networks with hybrid precoding architectures. Considering joint transmissions and BS silence strategy, we propose hybrid precoding algorithms which minimize the…
MIMO systems are considered as most promising for wireless communications. However, with an increasing number of radio front ends the corresponding energy consumption and costs become an issue, which can be relieved by the utilization of…
We consider the downlink of a single-cell multi-user MIMO system in which the base station makes use of $N$ antennas to communicate with $K$ single-antenna user equipments (UEs) randomly positioned in the coverage area. In particular, we…
To keep the hardware costs of future communications systems manageable, the use of low-cost hardware components is desirable. This is particularly true for the emerging massive multiple-input multiple-output (MIMO) systems which equip base…