Related papers: Blip glitches in Advanced LIGO data
"Blip glitches" are a type of short duration transient noise in LIGO data. The cause for the majority of these is currently unknown. Short duration transient noise creates challenges for searches of the highest mass binary black hole…
Advanced LIGO data contains numerous noise transients, or "glitches", that have been shown to reduce the sensitivity of matched filter searches for gravitational waves from compact binaries by increasing the rate at which random…
Gravitational-wave observatories become more sensitive with each observing run, increasing the number of detected gravitational-wave signals. A limiting factor in identifying these signals is the presence of transient non-Gaussian noise,…
"Glitches" -- transient noise artifacts in the data collected by gravitational wave interferometers like LIGO and Virgo -- are an ever-present obstacle for the search and characterization of gravitational wave signals. With some having…
Data streams of gravitational-wave detectors are polluted by transient noise features, or "glitches", of instrumental and environmental origin. In this work, we investigate the use of total-variation methods and learned dictionaries to…
Understanding the noise in gravitational-wave detectors is central to detecting and interpreting gravitational-wave signals. Glitches are transient, non-Gaussian noise features that can have a range of environmental and instrumental…
The LIGO observatories detect gravitational waves through monitoring changes in the detectors' length down to below $10^{-19}$\,$m/\sqrt{Hz}$ variation---a small fraction of the size of the atoms that make up the detector. To achieve this…
Data recorded by gravitational wave detectors includes many non-astrophysical transient noise bursts, the most common of which is caused by scattered-light within the detectors. These so-called ``glitches'' in the data impact the ability to…
The observation of gravitational waves is hindered by the presence of transient noise (glitches). We study data from the third observing run of the Advanced LIGO detectors, and identify new glitch classes. Using training sets assembled by…
On September 14, 2015, a gravitational wave signal from a coalescing black hole binary system was observed by the Advanced LIGO detectors. This paper describes the transient noise backgrounds used to determine the significance of the event…
Data from gravitational-wave (GW) detectors often contains a high rate of non-Gaussian transient noise, known as glitches. The parameters estimated from GW signals coinciding with detector glitches are occasionally biased away from their…
Gravitational-wave (GW) data contains non-Gaussian noise transients called "glitches". During the third LIGO-Virgo observing run about 24% of all gravitational-wave candidates were in the vicinity of a glitch, while even more events could…
Data from ground-based gravitational-wave detectors like LIGO contain many types of noise. Glitches are short bursts of non-Gaussian noise that may hinder our ability to identify or analyse gravitational-wave signals. They may have…
Data from ground-based gravitational-wave detectors contains numerous short-duration instrumental artifacts, called "glitches." The high rate of these artifacts in turn results in a significant fraction of gravitational-wave signals from…
Gravitational wave bursts are transient signals distinct from compact binary mergers that arise from a wide variety of astrophysical phenomena. Because most of these phenomena are poorly modeled, the use of traditional search methods such…
The number of astrophysical sources detected by Advanced LIGO and Virgo is expected to increase as the detectors approach their design sensitivity. Gravitational wave detectors are also sensitive to transient noise sources created by the…
This paper presents the results of a search for generic short-duration gravitational-wave transients in data from the third observing run of Advanced LIGO and Advanced Virgo. Transients with durations of milliseconds to a few seconds in the…
We present the results of a search for short-duration gravitational-wave transients in the data from the second observing run of Advanced LIGO and Advanced Virgo. We search for gravitational-wave transients with a duration of milliseconds…
We present the results from an all-sky search for short-duration gravitational waves in the data of the first run of the Advanced LIGO detectors between September 2015 and January 2016. The search algorithms use minimal assumptions on the…
Glitches are transitory noise artifacts that degrade the detection sensitivity and accuracy of interferometric observatories such as LIGO and Virgo in gravitational wave astronomy. Reliable glitch subtraction techniques are essential for…