Related papers: Transceiver Design for Ambient Backscatter Communi…
Low-power ambient backscatter communication (AmBC) relying on radio-frequency (RF) energy harvesting is an energy-efficient solution for batteryless Internet of things (IoT). However, ambient backscatter signals are severely faded by dyadic…
This paper investigates the problem of hybrid precoder and combiner design for multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems operating in millimeter-wave (mmWave) bands. We propose a novel…
The advancement of wireless communication systems toward 5G and beyond is spurred by the demand for high data rates, exceedingly dependable low-latency communication, and extensive connectivity that aligns with sensing requisites such as…
Integrated sensing and communication (ISAC) is a promising candidate technology for 6G due to its improvement in spectral efficiency and energy efficiency. Orthogonal frequency division multiplexing (OFDM) signal is a mainstream candidate…
Orthogonal Frequency Division Multiplexing (OFDM) is the dominant waveform in modern wireless systems, but suffers performance degradation in high-mobility environments due to Doppler-induced inter-carrier interference and unreliable…
We propose a new artificial-noise aided hybrid time-switching/power-splitting scheme for orthogonal frequency-division multiplexing (OFDM) systems to securely transmit data and transfer energy to a legitimate receiving node. In our proposed…
Orthogonal Frequency-Division Multiplexing (OFDM) is widely used in modern wireless communication systems due to its robustness against time-dispersive channels. In this work, we consider a non-cooperative scenario where the receiver does…
Ultra-reliable wireless communication links require the utilization of all diversity sources of a wireless communication channel. Hadani et al. propose a two dimensional discrete symplectic Fourier transform (DSFT) as orthogonal pre-coder…
Ambient backscatter communication (AmBC) offers low-cost and low-power connectivity for Internet of Things (IoT), where a backscatter tag (BT) modulates incident signals transmitted by an ambient radio frequency (RF) source and reflects…
The next generation of wireless communication technology is anticipated to address the communication reliability challenges encountered in high-speed mobile communication scenarios. An Orthogonal Time Frequency Space (OTFS) system has been…
Backscatter communication (BC) has emerged as a key technology to satisfy the increasing need for low-cost and green Internet-of-Things (IoT) connectivity, especially in large-scale deployments. Unlike the monostatic BC (MoBC), the bistatic…
Ambient backscatter communication (AmBC) has emerged as a highly attractive paradigm for energy-efficient communication. Full-duplex multi-tag AmBC systems provide the scalability and efficient spectrum utilization essential for next…
In this paper, a communication network using single carrier with cyclic prefix modulation over frequency selective channels is considered, where an access point provides connectivity to a legitimate destination through multiple transmitters…
In this paper we address the linear precoding and decoding design problem for a bidirectional orthogonal frequencydivision multiplexing (OFDM) communication system, between two multiple-input multiple-output (MIMO) full-duplex (FD) nodes.…
N-continuous orthogonal frequency division multiplexing (NC-OFDM) is a promising technique to obtain significant sidelobe suppression for baseband OFDM signals, in future 5G wireless communications. However, the precoder of NC-OFDM usually…
Orthogonal frequency-division multiplexing (OFDM) is widely adopted for providing reliable and high data rate communication in high-speed train systems. However, with the increasing train mobility, the resulting large Doppler shift…
In this article, we consider the problem of loop-back interference suppression for orthogonal frequency division multiplexing (OFDM) signals in amplify-and-forward single-frequency full-duplex relay stations. The loop-back interference…
When several wireless users are sharing the spectrum, packet collision is a simple, yet widely used model for interference. Under this model, when transmitters cause interference at any of the receivers, their collided packets are discarded…
Wireless channels generally exhibit dispersion in both time and frequency domain, known as doubly selective or doubly dispersive channels. To combat the delay spread effect, multicarrier modulation (MCM) such as orthogonal frequency…
Channel estimation and signal detection are very challenging for an orthogonal frequency division multiplexing (OFDM) system without cyclic prefix (CP). In this article, deep learning based on orthogonal approximate message passing…