Related papers: A Hardware-Efficient Hybrid Beamforming Solution f…
Hybrid beamforming has been widely employed in mmWave communications such as vehicular-to-everything (V2X) scenarios, as a compromise between hardware complexity and spectral efficiency. However, the inherent coupling between analog and…
This paper studies hybrid beamforming for active sensing applications, such as millimeter-wave or ultrasound imaging. Hybrid beamforming can substantially lower the cost and power consumption of fully digital sensor arrays by reducing the…
Multiple-input multiple-output (MIMO) systems exploit spatial diversity to facilitate multi-user communications with high spectral efficiency by beamforming. As MIMO systems utilize multiple antennas and radio frequency (RF) chains, they…
In this paper, we consider a prospective receiving hybrid beamforming structure consisting of several radio frequency (RF) chains and abundant antenna elements in multi-input multi-output (MIMO) systems. Due to conventional costly full…
Multi-cell wireless systems usually suffer both intra-cell and inter-cell interference, which can be mitigated via coordinated multipoint (CoMP) techniques. Previous works on multi-cell analysis for the microwave band generally consider…
The combination of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems and index modulation (IM) technique has recently constituted a novel form of mmWave hybrid beamforming. Lots of studies have been conducted to show…
It is challenging to precisely configure the phase shifts of the reflecting elements at the reconfigurable intelligent surface (RIS) due to inherent hardware impairments (HIs). In this paper, the mean square error (MSE) performance is…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
Cell-free massive multiple-input-multiple-output (CF-mMIMO) is regarded as one of the promising technologies for next-generation wireless networks. However, due to its distributed architecture, geographically separated access points (APs)…
In mmWave massive multiple-input multiple-output (mMIMO) systems, hybrid digital/analog beamforming has been recognized as an economic means to overcome the severe mmWave propagation loss. To facilitate beamforming for mmWace mMIMO, there…
In this paper, we propose a novel joint hybrid precoder and combiner design for maximizing the average achievable sum-rate of single-user orthogonal frequency division multiplexing millimeter wave massive MIMO systems. We formulate the…
In this paper, we propose a sequential hybrid beamforming design for multi-link transmission over mmwave frequency bands. As a starting point, a baseline data communication link is established via traditional analog beamforming at both the…
Data rate requirements for cellular communications are expected to increase 1000-fold by 2020, compared to 2010. This is mainly because of the rapid increase in the number of wireless devices and data hungry applications per-device. This…
In millimeter wave (mmWave) systems, antenna architecture limitations make it difficult to apply conventional fully digital precoding techniques but call for low cost analog radio-frequency (RF) and digital baseband hybrid precoding…
Joint communications and sensing (JCAS) is envisioned as a key feature in future wireless communications networks. In massive MIMO-JCAS systems, hybrid beamforming (HBF) is typically employed to achieve satisfactory beamforming gains with…
For massive MIMO public channel with any sector size in either microwave or millimeter wave (mmwave) band, this paper studies the beamforming design to minimize the transmit power while guaranteeing the quality of service (QoS) for randomly…
Full duplex (FD) is an auspicious wireless technology that holds the potential to double data rates through simultaneous transmission and reception. This paper proposes two innovative designs of hybrid beamforming (HYBF) for a multicell…
Distributed phased arrays based multiple-input multiple-output (DPA-MIMO) is a newly introduced architecture that enables both spatial multiplexing and beamforming while facilitating highly reconfigurable hardware implementation in…
In this paper, we study the design of a hybrid precoder, consisting of an analog and a digital precoder, for the delivery phase of downlink cache-enabled millimeter wave (mmWave) radio access networks (CeMm-RANs). In CeMm-RANs, enhanced…
This paper considers a wideband millimeter-wave MIMO system with fully digital transceivers at both the base station and the user equipment (UE), focusing on mobile scenarios. To reduce the baseband processing burden at the UE, we propose a…