Related papers: Double-Sequence Frequency Synchronization for Wide…
Millimeter-wave (mmWave) technology is a crucial enabler for next-generation networks because it offers substantially greater available bandwidth. mmWave multiple-input multiple-output (MIMO) systems cannot rely solely on fully digital…
High-resolution fully digital transceivers are infeasible at millimeter-wave (mmWave) due to their increased power consumption, cost, and hardware complexity. The use of low-resolution converters is one possible solution to realize fully…
Millimeter wave (mmWave) massive multiple-input multiple-output (massive MIMO) is one of the most promising technologies for the fifth generation and beyond wireless communication system. However, a large number of antennas incur high power…
We consider the problem of channel estimation for uplink multiuser massive MIMO systems, where, in order to significantly reduce the hardware cost and power consumption, one-bit analog-to-digital converters (ADCs) are used at the base…
This paper considers a wideband millimeter-wave MIMO system with fully digital transceivers at both the base station and the user equipment (UE), focusing on mobile scenarios. To reduce the baseband processing burden at the UE, we propose a…
This paper addresses carrier frequency offset (CFO) estimation and training sequence design for multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems over frequency selective fading channels. By…
Using a very low-resolution analog-to-digital convertor (ADC) unit at each antenna can remarkably reduce the hardware cost and power consumption of a massive multiple-input multiple-output (MIMO) system. However, such a pure low-resolution…
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array…
The problem of beam alignment (BA) in a cell-free massive multiple-input multiple-output (CF-mMIMO) system operating at millimeter wave (mmWaves) carrier frequencies is considered in this paper. Two estimation algorithms are proposed, in…
In this work, we consider a full-duplex (FD) massive multiple-input multiple-output (MIMO) cellular network with low-resolution analog-to-digital converters (ADCs) and digital-to-analog converter (DACs). Our first contribution is to provide…
The aim of this paper is to investigate the recently developed mixed-ADC architecture for frequency-selective channels. Multi-carrier techniques such as orthogonal frequency division multiplexing (OFDM) are employed to handle inter-symbol…
Millimeter wave (mmWave) MIMO will likely use hybrid analog and digital precoding, which uses a small number of RF chains to avoid energy consumption associated with mixed signal components like analog-to-digital components not to mention…
Hybrid analog/digital precoding offers a compromise between hardware complexity and system performance in millimeter wave (mmWave) systems. This type of precoding allows mmWave systems to leverage large antenna array gains that are…
Mobile edge computing (MEC) and millimeter wave (mmWave) communications are capable of significantly reducing the network's delay and enhancing its capacity. In this paper we investigate a mmWave and device-to-device (D2D) assisted MEC…
Millimeter-wave communications is the most promising technology for next-generation cellular wireless systems, thanks to the large bandwidth available compared to sub-6 GHz networks. Nevertheless, communication at these frequencies requires…
As a key enabling technology for 5G wireless, millimeter wave (mmWave) communication motivates the utilization of large-scale antenna arrays for achieving highly directional beamforming. However, the high cost and power consumption of RF…
The use of low-resolution analog-to-digital converters (ADCs) is considered to be an effective technique to reduce the power consumption and hardware complexity of wireless transceivers. However, in systems with low-resolution ADCs,…
In recent years, there has been extensive research on millimeter-wave (mmWave) communication and on in-band full-duplex (FD) communication, but work on the combination of the two is relatively lacking. FD mmWave systems could offer…
Motivated by the demand for energy-efficient communication solutions in the next generation cellular network, a mixed-ADC architecture for massive multiple input multiple output (MIMO) systems is proposed, which differs from previous works…
There is considerable interest in the combined use of millimeter-wave (mmwave) frequencies and arrays of massive numbers of antennas (massive MIMO) for next-generation wireless communications systems. A symbiotic relationship exists between…