Related papers: Millimeter Wave Receiver Comparison Under Energy v…
The difficulty of modeling energy consumption in communication systems leads to challenges in energy harvesting (EH) systems, in which nodes scavenge energy from their environment. An EH receiver must harvest enough energy for demodulating…
In this paper, we study energy-efficient resource allocation in distributed antenna system (DAS) with wireless power transfer, where time-division multiple access (TDMA) is adopted for downlink multiuser information transmission. In…
The power consumption of high-speed, high-resolution analog to digital converters (ADCs) is a limiting factor in implementing large-bandwidth mm-wave communication systems. A mitigating solution, which has drawn considerable recent…
Achieving high channel estimation accuracy and reducing hardware cost as well as power dissipation constitute substantial challenges in the design of massive multiple-input multiple-output (MIMO) systems. To resolve these difficulties,…
The massive Multiple-Input Multiple-Output (mMIMO) concept has been recently moving forward to extreme scales to address the envisioned requirements of next generation networks. However, the extension of conventional architectures will…
A game-theoretic analysis is used to study the effects of receiver choice and transmit power on the energy efficiency of multi-hop networks in which the nodes communicate using Direct-Sequence Code Division Multiple Access (DS-CDMA). A Nash…
Analog to digital conversion is a very important part of almost all beam instrumentation systems. Ideally, in a properly designed system, the used analog to digital converter (ADC) should not limit the system performance. However, despite…
This paper investigates the design of analog beamforming at the receiver in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) systems, aided by full digital chains featuring 1-bit ADCs. We advocate utilizing these full digital…
The design and measurement results of ultra-low power, fast 10-bit Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) prototypes in 65 nm CMOS technology are presented. Eight prototype ADCs were designed using two…
Hybrid analog/digital precoding offers a compromise between hardware complexity and system performance in millimeter wave (mmWave) systems. This type of precoding allows mmWave systems to leverage large antenna array gains that are…
In this paper, we consider the uplink channel estimation phase and downlink data transmission phase of cell-free millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems with low-capacity fronthaul links and…
Smart multiantenna wireless power transmission can enable perpetual operation of energy harvesting (EH) nodes in the internet-of-things. Moreover, to overcome the increased hardware cost and space constraints associated with having large…
Voltage Source Converters (VSC) are becoming more common in modern High Voltage DC (HVDC) transmission systems. One of the major challenges in a multi-terminal VSCHVDC is protection against DC side faults. Two major designs, namely, the…
Key parameters of analog-to-digital converters (ADCs) are their sampling rate and dynamic range. Power consumption and cost of an ADC are directly proportional to the sampling rate; hence, it is desirable to keep it as low as possible. The…
In this work, we consider the acquisition of stationary signals using uniform analog-to-digital converters (ADCs), i.e., employing uniform sampling and scalar uniform quantization. We jointly optimize the pre-sampling and reconstruction…
This paper investigates the hybrid precoding design in millimeter-wave (mmWave) systems with a fully-adaptive-connected precoding structure, where a switch-controlled connection is deployed between every antenna and every radio frequency…
Underlay in-band device-to-device (D2D) multicast communication, where the same content is disseminated via direct links in a group, has the potential to improve the spectral and energy efficiencies of cellular networks. However, most of…
All-digital massive multiuser (MU) multiple-input multiple-output (MIMO) at millimeter-wave (mmWave) frequencies is a promising technology for next-generation wireless systems. Low-resolution analog-to-digital converters (ADCs) can be…
Automatic repeat request (ARQ) is widely used in modern communication systems to improve transmission reliability. In conventional ARQ protocols developed for systems with energy-unconstrained receivers, an…
To ensure reliable communication in randomly varying and error-prone channels, wireless systems use adaptive modulation and coding (AMC) as well as hybrid ARQ (HARQ). In order to elucidate their compatibility and interaction, we compare the…