Related papers: Millimeter Wave Receiver Comparison Under Energy v…
High resolution analog to digital converters (ADCs) are conventionally used at the receiver terminals to store an accurate digital representation of the received signal, thereby allowing for reliable decoding of transmitted messages.…
Analog to digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) receivers in large bandwidth millimeter-wave systems. Prior works have considered two mitigating solutions to…
Millimeter wave (mmWave) systems operating over a wide bandwidth and using a large number of antennas impose a heavy burden on power consumption. In a massive multiple-input multiple-output (MIMO) uplink, analog-to-digital con- verters…
Power consumption is a key challenge in millimeter wave (mmWave) receiver front-ends, due to the need to support high dimensional antenna arrays at wide bandwidths. Recently, there has been considerable work in developing low-power…
Low-resolution analog-to-digital converters (ADCs) have emerged as a promising technology for reducing power consumption and complexity in massive multiple-input multiple-output (MIMO) systems while maintaining satisfactory spectral and…
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems is a favorable candidate for the fifth generation (5G) cellular systems. However, a key challenge is the high power consumption imposed by its numerous…
Low-resolution analog-to-digital converters (ADCs) have emerged as an efficient solution for massive multiple-input multiple-output (MIMO) systems to reap high data rates with reasonable power consumption and hardware complexity. In this…
This paper considers uplink massive multiple-input multiple-output (MIMO) systems with lowresolution analog-to-digital converters (ADCs) over Rician fading channels. Maximum-ratio-combining (MRC) and zero-forcing (ZF) receivers are…
Future wireless communications will rely on multiple-input multiple-output (MIMO) beamforming operating at millimeter wave (mmWave) frequency bands to deliver high data rates. To support flexible spatial processing and meet the demands of…
Hybrid analog/digital architectures and receivers with low-resolution analog-to-digital converters (ADCs) are two low power solutions for wireless systems with large antenna arrays. Most prior work represents two extreme cases in which…
This paper investigates the energy efficiency (EE) and spectral efficiency (SE) trade-off in uplink distributed massive multiple-input multiple-output (D-mMIMO) systems. Unlike conventional approaches where power consumption focuses…
The low-resolution analog-to-digital convertor (ADC) is a promising solution to significantly reduce the power consumption of radio frequency circuits in massive multiple-input multiple-output (MIMO) systems. In this letter, we investigate…
Due to the power consumption and high circuit cost in antenna arrays, the practical application of massive multiple-input multiple-output (MIMO) in the sixth generation (6G) and future wireless networks is still challenging. Employing…
Multiple-input multiple-output (MIMO) systems exploit spatial diversity to facilitate multi-user communications with high spectral efficiency by beamforming. As MIMO systems utilize multiple antennas and radio frequency (RF) chains, they…
We consider a wideband integrated access and backhaul system operating in full-duplex mode between the New Radio gNB donor and single user equipment. Due to high power consumption in millimeter wave systems, we use low-resolution…
This paper investigates the tradeoff between energyefficiency (EE) and spectral-efficiency (SE) for full-duplex (FD) enabled cellular networks.We assume that small cell base stations are working in the FD mode while user devices still work…
Inspired by the direct use of alternating current (AC) for computation, we propose a novel integrated information and energy receiver architecture for simultaneous wireless information and power transfer (SWIPT) networks. In this context,…
In Massive MIMO base stations (BSs), the hardware design needs to balance high spectral efficiency (SE) with low complexity. The level of hardware impairments (HWIs) indicates how strong the signal distortion introduced by hardware…
When designing wireless communication systems (WCS), spectral efficiency (SE) has been the main design performance metric. Recently, energy efficiency (EE) is attracting a huge interest due to the massive deployment of power limited WCS…
This paper analyzes the performance of multicell massive multiple-input and multiple-output (MIMO) systems with variable-resolution analog-to-digital converters (ADCs). In such an architecture, each ADC uses arbitrary quantization…