Related papers: Total Power Minimization: Joint Antenna Selection …
To utilize the full potential of the available power at a base station (BS), we propose a joint precoding, antenna selection, and transmit power control algorithm for a total power budget at the BS. We formulate a sum spectral efficiency…
Pinching-antenna systems (PASS) have recently attracted significant attention as a promising architecture for flexible and reconfigurable wireless communications. Despite notable advancements, research on energy efficiency (EE) maximization…
This paper considers the jointly optimal pilot and data power allocation in single-cell uplink massive multiple-input-multiple-output (MIMO) systems. Using the spectral efficiency (SE) as performance metric and setting a total energy budget…
This paper studies the joint optimization problem of two-way relay beamforming, the receiver power splitting (PS) ratio as well as the transmit power at the sources to maximize the achievable sum-rate of a simultaneous wireless information…
The problem of minimizing the total power consumption while satisfying different quality-of-service (QoS) requirements in a two-hop multiple-input multiple-output network with a single non-regenerative relay is considered. As shown by Y.…
Assume that a multi-user multiple-input multiple-output (MIMO) system is designed from scratch to uniformly cover a given area with maximal energy efficiency (EE). What are the optimal number of antennas, active users, and transmit power?…
In this paper, we design an association scheme to maximize the sum energy efficiency for massive multiple-input and multiple-output (MIMO) enabled heterogeneous cellular networks (HCNs). Considering that the final formulated problem is in a…
In this paper, an energy harvesting scheme for a multi-user multiple-input-multiple-output (MIMO) secrecy channel with artificial noise (AN) transmission is investigated. Joint optimization of the transmit beamforming matrix, the AN…
This paper examines the problem of state estimation in power distribution systems under low-observability conditions. The recently proposed constrained matrix completion method which combines the standard matrix completion method and power…
Signal-to-interference plus noise ratio (SINR) percolation is an infinite-range dependent variant of continuum percolation modeling connections in a telecommunication network. Unlike in earlier works, in the present paper the transmitted…
The rate optimization for wireless networks with low SNR is investigated. While the capacity in the limit of disappearing SNR is known to be linear for fading and non-fading channels, we study the problem of operating in low SNR wireless…
The pinching-antenna system (PASS) reconstructs wireless channels through pinching beamforming, i.e., optimizing the activated locations of pinching antennas (PAs) along the waveguide. The aim of this article is to investigate the joint…
This paper proposes energy-efficient coordinated beamforming strategies for multi-cell multi-user multiple-input single-output system. We consider a practical power consumption model, where part of the consumed power depends on the base…
Due to the large power consumption in RF-circuitry of massive MIMO systems, practically relevant performance measures such as energy efficiency or bandwidth efficiency are neither necessarily monotonous functions of the total transmit power…
In this paper, we study optimization of multi-tone signals for wireless power transfer (WPT) systems. We investigate different non-linear energy harvesting models. Two of them are adopted to optimize the multi-tone signal according to the…
In this paper we explore non-orthogonal multiple access (NOMA) in millimeter-wave (mmWave) communications (mmWave-NOMA). In particular, we consider a typical problem, i.e., maximization of the sum rate of a 2-user mmWave-NOMA system. In…
To synthesize proteins in a cell, an mRNA has to work with a finite pool of ribosomes. When this constraint is included in the modeling by a totally asymmetric simple exclusion process (TASEP), non-trivial consequences emerge. Here, we…
In this paper, we study a multi-sine multiple-input multiple-output (MIMO) wireless power transfer (WPT) system with the objective to increase the output DC power. We jointly optimize the multi-sine waveform and beamforming accounting for…
Wireless power transfer (WPT) is expected to be a technology reshaping the landscape of low-power applications such as the Internet of Things, machine-to-machine communications and radio frequency identification networks. Although there has…
We consider a new approach to power control in decentralized wireless networks, termed fractional power control (FPC). Transmission power is chosen as the current channel quality raised to an exponent -s, where s is a constant between 0 and…