Related papers: Infrared Thermography of Complex 3D Printed Compon…
3D silicon pixel detectors have been investigated as radiation-hard candidates for the innermost layers of the HL-LHC upgrade of the ATLAS pixel detector. 3D detectors are already in use today in the ATLAS IBL and AFP experiments. These are…
We use a Sagnac interferometer to measure the dispersive and absorptive properties of room temperature Rubidium vapor on the D_2 line at 780.2 nm. We apply a pump beam such that the resulting Lambda system exhibits Electromagnetically…
We present a technique based on high resolution imaging to measure the absolute temperature and the heating rate of a single ion trapped at the focus of a deep parabolic mirror. We collect the fluorescence light scattered by the ion during…
We present a new technique for measuring the integrated galaxy light (IGL) with stacked image data from the Dark Energy Survey (DES). We extract $1\times1$ arcminute cutouts from nearly 100,000 randomly selected positions in the g, r, i, z,…
Strained layer superlattice (SLS) detectors are a new class of infrared detectors available in the scientific and commercial markets. The photosensitive bandpass is set by material and engineered properties with typical detectors covering…
This paper analyzes a transient method for the characterization of low-resistance thermal interfaces of microelectronic packages. The transient method can yield additional information about the package not available with traditional static…
Measurement of stray light in a complex optical system can be a complex task. We developed a method to measure coherent stray light inside an assembled device, determining all stray light sources and their relative contribution. The method…
We propose three different lattice operators to measure the intrinsic width \xi_I of the chromoelectric flux tube in pure lattice gauge theories. In order to test these proposals we evaluate them for SU(2) and Ising LGTs in (2+1) dimensions…
Luminescence thermometry has been extensively exploited in the last decades both from the fundamental and applied point of views. The application of photoluminescent nanoparticles on the microscopic level based on rare-earth doped (RED)…
In a recent experiment, Lai et al. [Phys. Rev. B 75 (2007) 033314] studied the apparent metal-insulator transition (MIT) of a Si quantum well structure. Tuning the charge carrier concentration n, they measured the conductivity sigma(T,n)…
We present a computational study of isochoric heating in multi-layered targets at ultra-high intensity laser irradiation (approx. 10**20 W/cm**2). Previous studies have shown enhanced ion heating at interfaces, but at the cost of large…
High-resolution temperature measurements are required in the LTP, i.e., 10 uK/sqrt(Hz) from 1 mHz to 30 mHz. This has been already accomplished with thermistors and a suitable low noise electronics. However, the frequency range of interest…
We demonstrate spin gradient thermometry, a new general method of measuring the temperature of ultracold atoms in optical lattices. We realize a mixture of spins separated by a magnetic field gradient. Measurement of the width of the…
We decompose the Lyman-{\alpha} (Ly{\alpha}) forest of an extensive sample of 74 high signal-to-noise ratio and high-resolution quasar spectra into a collection of Voigt profiles. Absorbers located near caustics in the peculiar velocity…
Low Gain Avalanche Diode (LGAD) is applied for the High-Granularity Timing Detector (HGTD), and it will be used to upgrade the ATLAS experiment. The first batch IHEP-IME LGAD sensors were designed by the Institute of High Energy Physics…
The Infra-Red Video Bolometer (IRVB) is a diagnostic equipped with an infra-red camera that measures the total radiated power in thousands of LOSs within a large field of view (FOV). Recently validated in MAST-U, it offers a high spatial…
Line intensity mapping (LIM) is a promising tool to efficiently probe the three-dimensional large-scale structure by mapping the aggregate emission of a spectral line from all sources that trace the matter density field. Spectral lines from…
Ultrathin microscale resistive thermometers are of key value to many applications. Here we have fabricated a laser machined 50 ${\mu}$m wide and 50 nm thick serpentine Pt thin film sensor capable of sensing temperatures up to 650 ${^\circ}$…
The solid-state diffusion coefficient of the electrode active material is one of the key parameters in lithium-ion battery modelling. Conventionally, this diffusion coefficient is estimated through the galvanostatic intermittent titration…
We report the design and development of a compact, integrated laser heating stage tailored for in situ high-temperature X ray transmission studies of molten oxides. In horizontal beam geometries, widely used in both laboratory and…