Related papers: Atmospheric turbulence forecasting with a General …
Knowledge of the Earth's atmospheric optical turbulence is critical for astronomical instrumentation. Not only does it enable performance verification and optimisation of existing systems but it is required for the design of future…
As telescopes become larger, into the era of ~40 m Extremely Large Telescopes, the high- resolution vertical profile of the optical turbulence strength is critical for the validation, optimization and operation of optical systems. The…
We describe the implementation of a robotic SLODAR instrument at the Cerro Paranal observatory. The instrument measures the vertical profile of the optical atmospheric turbulence strength, in 8 resolution elements, to a maximum altitude…
The next generation of adaptive optics (AO) systems will require tomographic reconstruction techniques to map the optical refractive index fluctuations, generated by the atmospheric turbulence, along the line of sight to the astronomical…
For extremely large telescopes, adaptive optics will be required to correct the Earth's turbulent atmosphere. The performance of tomographic adaptive optics is strongly dependent on the vertical distribution (profile) of this turbulence. An…
Results of 3-month continuous monitoring of turbulence profile and seeing at Cerro Tololo (Chile) in May-July 2002 are presented. Some 28000 low-resolution profiles were measured by a new MASS single-star turbulence monitor, accompanied by…
A six-night optical turbulence monitoring campaign has been carried at Cerro Paranal observatory in February and March, 2023 to facilitate the development and characterisation of two novel atmospheric site monitoring instruments - the…
We present optical turbulence profiles obtained with a Generalized SCIDAR (G-SCIDAR) and a Low Layer SCIDAR (LOLAS) at the Observatorio Astron\'omico Nacional in San Pedro M\'artir (OAN-SPM), Baja California, Mexico, during three observing…
We present the overview of the MOSE project (MOdeling ESO Sites) aiming at proving the feasibility of the forecast of the classical atmospherical parameters (wind speed intensity and direction, temperature, relative humidity) and the…
The performance of tomographic adaptive optics systems is intrinsically linked to the vertical profile of optical turbulence. Firstly, a sufficient number of discrete turbulent layers must be reconstructed to model the true continuous…
We present first results of a simultaneous atmospheric turbulence measurement campaign at the Calar Alto (Spain) 1.23m and 3.5m telescopes. A SCIDAR instrument and the Calar Alto Adaptive Optics system ALFA were used at the 1.23m and 3.5m…
Current projects for large telescopes demand a proper knowledge of atmospheric turbulence to design efficient adaptive optics systems in order to reach large Strehl ratios. However, the proper characterization of the turbulence above a…
Generalized Scidar (GS) measurements taken at the Paranal Observatory in November/December 2007 in the context of a site qualification for the future European Extremely Large Telescope E-ELT are re-calibrated to overcome the bias induced on…
The strength and vertical distribution of atmospheric turbulence is a key factor determining the performance of optical and infrared telescopes, with and without adaptive optics. Yet, this remains challenging to measure. We describe a new…
Optical turbulence affects significantly the quality of ground-based astronomical observations. An accurate and reliable forecast of optical turbulence can help to optimise the scheduling of the science observations and to improve both the…
The Earth's atmosphere affects ground-based astronomical observations. Scattering, absorption, and radiation processes deteriorate the signal-to-noise ratio of the data received. For scheduling astronomical observations it is, therefore,…
We present a simple method of extracting a small number of reference optical turbulence and wind profiles from a large dataset for single conjugate and extreme adaptive optics simulations. These reference profiles can be used in slow…
Monitoring turbulence parameters is crucial in high-angular resolution astronomy for various purposes, such as optimising adaptive optics systems or fringe trackers. The former are present at most modern observatories and will remain…
Atmospheric optical turbulence seriously limits the performance of high angular resolution instruments. An 8-night campaign of measurements was carried out at the LAMOST site in 2011, to characterize the optical turbulence. Two instruments…
The mesoscale model Meso-NH is used to simulate the optical turbulence at Mt Graham (Arizona, USA), site of the Large Binocular Telescope. Measurements of the CN2-profiles obtained with a generalized scidar from 41 nights are used to…