Related papers: Rear-surface integral method for calculating therm…
High-reflectivity fused silica mirrors are at the epicentre of current advanced gravitational wave detectors. In these detectors, the mirrors interact with high power laser beams. As a result of finite absorption in the high reflectivity…
We present a multi-level delumping method suitable for thermal enhanced oil recovery processes, for which hydrocarbon components are vaporized under high temperatures, move downstream in the gas phase and condense back to the liquid phase.…
In scanning probe microscopy laser interferometers are usually used for measuring the position of the probe tip with a metrological traceability. As the most of the AFM setups are designed to work under standard atmospheric conditions the…
Thermal images from low-cost cameras often suffer from low resolution, fixed pattern noise, and other localized degradations. Available datasets for thermal imaging are also limited in both size and diversity. To address these challenges,…
The estimation of wall thermal properties by \emph{in situ} measurement enables to increase the reliability of the model predictions for building energy efficiency. Nevertheless, retrieving the unknown parameters has an important…
This work focuses on determining the coefficient of thermal diffusivity in a one-dimensional heat transfer process along a homogeneous and isotropic bar, embedded in a moving fluid with heat generation. A first type (Dirichlet) condition is…
The laser flash method is highly regarded due to its applicability to a wide temperature range, from cryogenic temperatures to the melting point of refractory metals, and to extreme environments involving radioactive or hazardous materials.…
We demonstrate a technique for obtaining the density of atomic vapor, by doing a fit of the resonant absorption spectrum to a density-matrix model. In order to demonstrate the usefulness of the technique, we apply it to absorption in the…
A switching-off process very similar to those in real high-voltage self-blast circuit-breakers is emulated in a model chamber to study the arc properties by optical emission spectroscopy. The arc is operated in a chamber filled with SF$_6$…
Absorption spectroscopy is traditionally used to determine the average gas temperature and species concentration along the laser line-of-sight by measuring the magnitude of two or more absorption transitions with different temperature…
This work builds on the previous introduction [1] of a coupled experimental-computational system devised to fully characterize the thermal behavior of complex 3D submicron electronic devices. The new system replaces the laser-based surface…
Recovering the past from present observations is an intriguing challenge with potential applications in forensics and scene analysis. Thermal imaging, operating in the infrared range, provides access to otherwise invisible information.…
The objective of this work is to investigate the coupling of fluid dynamics, heat transfer and mass transfer during the impact and evaporation of droplets on a heated solid substrate. A laser-based thermoreflectance method is used to…
Thermal mode spectroscopy (TMS) has been recently proposed for accurately measuring thermal diffusivity of solids from a temperature decay rate of a specific thermal mode selected by three- dimensional (anti)nodal information [Phys. Rev.…
In this Letter, we systematically investigate the Leidenfrost temperature for hot solid substrates with various thermal diffusivities and surface roughnesses. Based on the experimental results, we build a phenomenological model that…
In the described device, the thermal emissivity or absorptivity of the sample is measured by substitution of the radiative heat flow between two parallel surfaces by thermal output of a heater. Fast measurements of the mutual emissivity for…
This paper deals with the thermal performances of roof-mounted radiant barriers. Using dynamic simulations of a mathematical model of a whole test cell including a radiant barrier installed between the roof top and the ceiling, the thermal…
In this paper, an opto-thermal analysis of a moderately heated lightweighted solar telescope mirror is carried out using 3D finite element analysis (FEA). A physically realistic heat transfer model is developed to account for the radiative…
White light spectral interferometry is applied to measure the refractive index in absorbing liquids in the spectral range from 400 to 1000 nm. We analyze the influence of absorption on the visibility of interferometric fringes and,…
Desert mirages were simulated in the laboratory by heating a flat surface of sand. This showed that a boundary layer of air, of only a few millimeters immediately covering a heated surface has nearly the same thickness over a wide range of…