Related papers: Classification Algorithms for Semi-Blind Uplink/Do…
In this paper, the uplink adaptation for massive multiple-input-multiple-output (MIMO) networks without the knowledge of user density is considered. Specifically, a novel cooperative uplink transmission and detection scheme is first…
Deploying sub-6GHz network together with millimeter wave (mmWave) is a promising solution to simultaneously achieve sufficient coverage and high data rate. In the heterogeneous networks (HetNets), the traditional coupled access, i.e., the…
Decoupling uplink (UL) and downlink (DL) is a new architectural paradigm where DL and UL are not constrained to be associated to the same base station (BS). Building upon this paradigm, the goal of the present paper is to provide lower,…
One of the 5G promises is to provide Ultra Reliable Low Latency Communications (URLLC) which targets an end to end communication latency that is less than 1ms . The very low latency requirement of URLLC entails a lot of work in all…
In this paper, we propose low complexity algorithms based on Markov chain Monte Carlo (MCMC) technique for signal detection and channel estimation on the uplink in large scale multiuser multiple input multiple output (MIMO) systems with…
Massive MIMO OFDM waveforms help support a large number of users in the same time-frequency resource and also provide significant array gain for uplink reception in cellular systems. However, channel estimation in such large antenna systems…
For a base station that supports cellular communications in sub-6 GHz LTE and millimeter (mmWave) bands, we propose a supervised machine learning algorithm to improve the success rate in the handover between the two radio frequencies using…
We carry out a theoretical analysis of the uplink (UL) of a massive MIMO system with per-user channel correlation and Rician fading, using two processing approaches. Firstly, we examine the linear minimum-mean-square-error receiver under…
Downlink precoding is considered for multi-path multi-input single-output channels where the base station uses orthogonal frequency-division multiplexing and low-resolution signaling. A quantized coordinate minimization (QCM) algorithm is…
This paper proposes and analyzes novel deep learning methods for downlink (DL) single-user multiple-input multiple-output (SU-MIMO) and multi-user MIMO (MU-MIMO) systems operating in time division duplex (TDD) mode. A motivating application…
One of the fundamental challenges to realize massive Multiple-Input Multiple-Output (MIMO) communications is the accurate acquisition of channel state information for a plurality of users at the base station. This is usually accomplished in…
This work studies multiuser detection for one-bit massive multiple-input multiple-output (MIMO) systems in order to diminish the power consumption at the base station (BS). A low-complexity near-maximum-likelihood (nML) multiuser detection…
Acquiring accurate channel state information (CSI) at an access point (AP) is challenging for wideband millimeter wave (mmWave) ultra-massive multiple-input and multiple-output (UMMIMO) systems, due to the high-dimensional channel matrices,…
This paper considers the transceiver design for uplink massive multiple-input multiple-output (MIMO) systems with channel sparsity in the angular domain. Recent progress has shown that sparsity-learning-based blind signal detection is able…
This paper investigates the downlink (DL) transmission in millimeter-wave (mmWave) multi-user multiple-input single-output (MU-MISO) systems especially focusing on a high speed mobile scenario. To complete the DL transmission within an…
Millimeter Wave (mmWave) is an important part of 5G new radio (NR), in which highly directional beams are adapted to compensate for the substantial propagation loss based on UE locations. However, the location information may have some…
Millimeter wave (mmWave) links will offer high capacity but are poor at penetrating into or diffracting around solid objects. Thus, we consider a hybrid cellular network with traditional sub 6 GHz macrocells coexisting with denser mmWave…
To optimally cover users in millimeter-Wave (mmWave) networks, clustering is needed to identify the number and direction of beams. The mobility of users motivates the need for an online clustering scheme to maintain up-to-date beams towards…
Massive multiple-input multiple-output (MIMO) with frequency division duplex (FDD) mode is a promising approach to increasing system capacity and link robustness for the fifth generation (5G) wireless cellular systems. The premise of these…
In this paper, we study Simultaneous Communication of Data and Control (SCDC) information signals in Full Duplex (FD) Multiple-Input Multiple-Output (MIMO) wireless systems. In particular, considering an FD MIMO base station serving…