Related papers: An Isolated Power Factor Corrected Power Supply Ut…
Fault detection and reconfiguration in fault-tolerant converters may complicated and necessitate using all-purpose microprocessors and high-speed sensors to guarantee the satisfactory performance of power converters. Therefore, providing…
In the last decades, the applications of power inverter increased rapidly. As a result, in spite of rectifier, an inverter with a high-power electronic oscillator has capability to convert direct current (DC) into alternating current (AC)…
This research presents the mathematical model of an isolated wind-diesel-solar PV hybrid power system with conventional proportional-plus-integral controllers for load frequency control (LFC). In order to enhance the reliability of the…
The use of charge controllers in photovoltaic generation systems increases the energy harvested significantly. The most efficient type of charge controller is the Maximum Power Point Tracking (MPPT) controller. The commercially available…
Coordinated photovoltaic inverter control with centralized coordination of curtailment can increase the amount of energy sent from low-voltage (LV) distribution networks to the grid while respecting voltage constraints. First, this paper…
The power flow equations relate bus voltage phasors to power injections via the network admittance matrix. These equations are central to the key operational and protection functions of power systems (e.g., optimal power flow scheduling and…
This paper proposes a novel strategy for the current injection based control for distributed energy resources connected to weak grids through a voltage source converter experiencing faults. The current injection controller is no longer…
In this paper, a non-isolated high step-up dc-dc converter is presented. The proposed converter is composed of an interleaved structure and diode-capacitor multiplier cells for interfacing low-voltage renewable energy sources to…
This paper discusses a dispersed generation system of multiple DC/DC converters with DC power sources connected in a ring formulation. Here is presented the analysis of the system based on the stored energy and passivity characteristics of…
Power converters inherently display non-linear load characteristics, resulting in a high level of mains harmonics, and hence the necessity of implementing Power Factor Correction (PFC). Active PFC circuitry typically comprises an inductor…
This paper proposes a nonlinear, adaptive controller to increase the stability margin of a direct-current (DC) small-scale electrical network containing a constant power load, whose value is unknown. Due to their negative incremental…
In this paper, a non-isolated high step-up DC-DC converter has been proposed for renewable energy applications. The proposed structure converter has been derived from the fundamental Zeta converter, in both of which only a single switch is…
Modern society critically depends on the services electric power provides. Power systems rely on a network of power lines and transformers to deliver power from sources of power (generators) to the consumers (loads). However, when power…
There is a trade-off between transient performance and line current distortion of the DC bus voltage control of single-phase grid-connected voltage source converters. This paper presents an improved DC bus voltage control scheme of such…
Reactive power sharing and containment of voltages within limits for inverter-based resources (IBRs) are two important, yet coupled objectives in ac networks. In this article, we propose a distributed control technique to simultaneously…
Rapid developments in power distribution systems and renewable energy have widened the applications of dc--dc buck--boost converters in dc voltage regulation. Applications include vehicular power systems, renewable energy sources that…
Power capacitor device is a widely used reactive power compensation equipment in power transmission and distribution system which can easily have internal fault and therefore affects the safe operation of the power system. An intelligent…
In this article, we propose a nonlinear voltage control to ensure power exchange in a multiport interconnected system, which consists of a bidirectional DC-DC converter and generating-storing devices. The converter topology under…
This paper presents a fuzzy inference system for integrated volt/var control (VVC) in distribution substations. The purpose is go forward to automation distribution applying conservation voltage reduction (CVR) in isolated power systems…
In this paper, we illustrate a new correct-by-construction switching controller for a power converter with event-triggered measurements. The event-triggered measurement scheme is beneficial for high frequency power converters because it…