Related papers: Micro-lens array as tip-tilt sensor for single-mod…
In ground-based astronomy, the ability to couple light into single-mode fibers (SMFs) is limited by atmospheric turbulence, which prohibits the use of many astrophotonic instruments. We propose a silicon-on-insulator photonic chip capable…
We demonstrate robust light coupling between two single-mode fibers for an out-door FSO link through a focal plane array beamformer with 61 fine-pitched fiber cores as antenna elements. We show that favourable coupling conditions are…
We report on the design and construction of a LED-based fiber calibration system for large liquid argon time projection detectors. This system was developed to calibrate the optical systems of the MicroBooNE experiment. As well as detailing…
Our objective is to prove that integrated optics (IO) is not only a good concept for astronomical interferometry but also a working technique with high performance. We used the commissioning data obtained with the dedicated K-band…
We theoretically demonstrate a fiber-integrated single photon source of unprecedented efficiency. This fiber single photon source is achieved by coupling optically a single quantum emitter to a monomode optical fiber with a new concept of…
Manipulation of the detected backscattered Rayleigh signal inside the bandwidth of a frequency-swept optical sub-carrier propagating into an optical fiber permits an efficient localization of faults through a Fourier operator. When the…
We experimentally realize an optical fiber ring resonator that includes a tapered section with subwavelength-diameter waist. In this section, the guided light exhibits a significant evanescent field which allows for efficient interfacing…
Event-based sensors detect only changes in brightness across a scene, with each pixel producing an asynchronous stream of spatial-temporal data, rather than recording frames of overall illumination such as a traditional frame-based sensor.…
This paper describes a setup aimed at measuring the so-called Tilt-To-Length (TTL) coupling in the optical benches of the LISA mission. The TTL is the coupling of the angular jitter of any optical setup into the optical path length between…
Transmission matrix measurements of multimode fibers are now routinely performed in numerous labs, enabling control of the electric field at the distal end of the fiber and paving the way for the potential application to ultrathin medical…
We present experimental demonstration of tilt-mirror assisted transmission structured illumination microscopy (tSIM) that offers a large field of view super resolution imaging. An assembly of custom-designed tilt-mirrors are employed as the…
Nitrogen-vacancy centres (NVs) are promising solid-state nanoscale quantum sensors for applications ranging from material science to biotechnology. Using multiple sensors simultaneously offers advantages for probing spatiotemporal…
We describe feedhorn-coupled polarization-sensitive detector arrays that utilize monocrystalline silicon as the dielectric substrate material. Monocrystalline silicon has a low-loss tangent and repeatable dielectric constant,…
Integrated Communication and Sensing (ICAS) is a key technology that enables sensing functionalities within the next-generation mobile communication (6G). Joint design and optimization of both functionalities could allow coexistence,…
We propose a method to simultaneously correct linear optics errors and linear coupling for storage rings using turn-by-turn (TbT) beam position monitor (BPM) data. The independent component analysis (ICA) method is used to isolate the…
In this work we present an elegant solution for a scintillation counter to be integrated into a cryogenic system. Its distinguishing feature is the absence of a continuous light guide coupling the scintillation and the photodetector parts,…
The PolyOculus technology produces large-area-equivalent telescopes by using fiber optics to link modules of multiple semi-autonomous, small, inexpensive, commercial-off-the-shelf telescopes. Crucially, this scalable design has construction…
We review a novel method for characterizing both the spectral and spatial properties of resonant cavities within two-dimensional photonic crystals (PCs). An optical fiber taper serves as an external waveguide probe whose micron-scale field…
Tunable photonic elements at the surface of an optical fiber with piezoelectric core are proposed and analyzed theoretically. These elements are based on whispering gallery modes whose propagation along the fiber is fully controlled by…
We demonstrate highly efficient coupling of light from an optical fiber to a silicon photonic crystal optomechanical cavity. The fiber-to-cavity coupling utilizes a compact (L ~ 25 um) intermediate adiabatic coupler. The optical coupling is…