Related papers: Digital frequency multiplexing with sub-Kelvin SQU…
We present the uplink and downlink of a time-division duplex distributed multiple-input multiple-output (D-MIMO) testbed, based on a 1-bit radio-over-fiber architecture, which is low-cost and scalable. The proposed architecture involves a…
Deep learning-based techniques for the analysis of multimodal remote sensing data have become popular due to their ability to effectively integrate complementary spatial, spectral, and structural information from different sensors.…
Mode-division multiplexing (MDM) is an emerging large-capacity data communication technology utilizing orthogonal guiding modes as independent data streams. One of the challenges of multimode waveguide routing in MDM systems is decreasing…
We demonstrate the code-division multiplexed (CDM) readout of eight transition-edge sensor microcalorimeters. The energy resolution is 3.0 eV (full width at half-maximum) or better at 5.9 keV, with a best resolution of 2.3 eV and a mean of…
Oversmoothing remains a persistent problem when applying deep learning to off-axis quantitative phase imaging (QPI). End-to-end U-Nets favour low-frequency content and under-represent fine, diagnostic detail. We trace this issue to spectral…
Recently, ultrasensitive calorimeters have been proposed as a resource-efficient solution for multiplexed qubit readout in superconducting large-scale quantum processors. However, experiments demonstrating frequency multiplexing of these…
CMB-S4 is the fourth-generation ground-based cosmic microwave background project, designed to probe the early universe and cosmic inflation. CMB-S4 would achieve its science goals in part by dramatically increasing the number of transition…
Infrared and visible image fusion aims to utilize the complementary information from two modalities to generate fused images with prominent targets and rich texture details. Most existing algorithms only perform pixel-level or feature-level…
In this paper, we propose a joint delay-Doppler estimation framework for Rydberg atomic quantum receivers (RAQRs) leveraging affine frequency division multiplexing (AFDM), as a future enabler of hyper integrated sensing and communication…
The readout of transition-edge sensor (TES) bolometers with a large multiplexing factor is key for the next generation Cosmic Microwave Background (CMB) experiment, Polarbear-2, having 7,588 TES bolometers. To enable the large arrays, we…
Multicast short video streaming can enhance bandwidth utilization by enabling simultaneous video transmission to multiple users over shared wireless channels. The existing network management schemes mainly rely on the sequential buffering…
Affine frequency division multiplexing (AFDM) has garnered significant attention due to its superior performance in high-mobility scenarios, coupled with multiple waveform parameters that provide greater degrees of freedom for system…
Space Division Multiplexing (SMD) is a very attractive technique for addressing the ever-growing demands in transmission capacity by enabling the use of a new parameter \textemdash\ space \textemdash\ to increase the number of channels in…
So far, performance prediction and optimization of microwave SQUID multiplexers has largely been based on simple approximate analytical models and experimental results. This is caused by the complexity of the underlying physics and the…
A photonic integrated circuit for mode multiplexing and demultiplexing in a few-mode fiber is presented and demonstrated. Two 10 Gbit/s channels at the same wavelength and polarization are simultaneously transmitted over modes LP01 and…
RFQ with a harmonic higher order quadrupole mode is studied. Assuming that we superpose a higher order mode with twice the frequency of the fundamental mode, a sawtooth waveform is approximated. In such a case, the bunching function is…
The on-demand tailoring of light's spatial shape is of great relevance in a wide variety of research areas. Computer-controlled devices, such as Spatial Light Modulators (SLMs) or Digital Micromirror Devices (DMDs), offer a very accurate,…
This paper presents a performance comparison of various MIMO radar multiplexing approaches where the increasing number of transmitters adversely affects the dynamic range of the resultant MIMO system. The investigated multiplexing…
The CMB-S4 experiment is developing next-generation ground-based microwave telescopes to observe the Cosmic Microwave Background with unprecedented sensitivity. This will require an order of magnitude increase in the 100 mK detector count,…
LiteBIRD is an upcoming JAXA-led mission that aims to measure primordial gravitational waves in the B-mode polarization of the cosmic microwave background. It is set to launch in 2032. The LiteBIRD detector array consists of around 5000 TES…