Related papers: Time-Delay Interferometry and Clock-Noise Calibrat…
The frequency stability achieved by an optical atomic clock ultimately depends on the coherence of its local oscillator. Even the best ultrastable lasers only allow interrogation times of a few seconds, at present. Here we present a…
The arm length and the isolation in space enable LISA to probe for signals unattainable on ground, opening a window to the sub-Hz gravitational-wave universe. The coupling of unavoidable angular spacecraft jitter into the longitudinal…
Unlike ground-based interferometric gravitational wave detectors, large space-based systems will not be rigid structures. When the end-stations of the laser interferometer are freely flying spacecraft, the armlengths will change due to…
The analysis of gravitational wave (GW) datasets is based on the comparison of measured time series with theoretical templates of the detector's response to a variety of source parameters. For LISA, the main scientific observables will be…
For space gravitational wave (GW) detection, arm locking is a proposal useful in decreasing the frequency noise of the laser sources for current developing space missions LISA and Taiji/TianQin. In this paper, we study the application of…
We address the two issues raised by Bayle, Vallisneri, Babak, and Petiteau (in their gr-qc document arXiv:2106.03976) about our matrix formulation of Time-Delay Interferometry (TDI) (arXiv:2105.02054) \cite{TDJ21}. In so doing we explain…
The orbiting LISA instrument is designed to detect gravitational waves in the millihertz band, produced by sources including galactic binaries and extreme mass ratio inspirals, among others. The detector consists of three spacecraft, each…
Space-borne gravitational-wave telescopes are key to extend the observation band below $10\,\mathrm{Hz}$. The use of inter-satellite optical cavities linked by heterodyne interferometry is a promising approach to reach the sensitivity level…
Over the past few years questions have been raised concerning the use of laser communications links between sciencecraft to transmit phase information crucial to the reduction of laser frequency noise in the LISA science measurement. The…
Satellite geodesy uses the measurement of the motion of one or more satellites to infer precise information about the Earth's gravitational field. In this work, we consider the achievable precision limits on such measurements by examining…
The European Space Agency (ESA) and the National Aeronautics and Space Administration (NASA) are planning the Laser Interferometer Space Antenna (LISA) mission in order to detect GW. The need of accurate testing of free-fall and knowledge…
Laser frequency stabilization is a critical part of the interferometry measurement system of space-based gravitational wave observatories such as the Laser Interferometer Space Antenna (LISA). Arm locking as a proposed frequency…
We report the progress in the realization of an electronic / optical simulator for space based, long arm interferometry and its application to the eLISA mission. The goal of this work is to generate realistic optics and electronics signals,…
For the laser interferometer space antenna (LISA) to reach it's design sensitivity, the coupling of the free running laser frequency noise to the signal readout must be reduced by more than 14 orders of magnitude. One technique employed to…
ASTROD-GW (ASTROD [Astrodynamical Space Test of Relativity using Optical Devices] optimized for Gravitation Wave detection) is an optimization of ASTROD to focus on the goal of detection of gravitation waves. The detection sensitivity is…
The response of the Advanced LIGO interferometers is known to vary with time [arXiv:1608.05134]. Accurate calibration of the interferometers must therefore track and compensate for temporal variations in calibration model parameters. These…
A radio interferometer uses time delays to maximize its response to radiation coming from a particular direction. These time delays compensate for differences in the time of arrival of the wavefront at the different elements of the…
The orbital motion of the Laser Interferometer Space Antenna (LISA) introduces modulations into the observed gravitational wave signal. These modulations can be used to determine the location and orientation of a gravitational wave source.…
The ESA/NASA joint LISA (laser interferometer space antenna) mission is designed to detect gravitational waves, which relies crucially on maintaining three-spacecraft constellation as close to an equilateral triangle with a designed…
Space-based gravitational wave (GW) detectors are designed for wave sources in the millihertz band with different locations and orientations. Time-delay interferometry (TDI) technique is an indispensable ingredient in space-borne GW…