Related papers: The CBM Time-of-Flight system

Biphoton frequency comb (BFC), which encompasses multiple discrete frequency modes and represents high-dimensional frequency entanglement, is crucial in quantum information processing due to its high information capacity and error…

A four-gap glass RPC with 0.3mm gap size was tested with hadron beam as a time-of-flight detector having a time resolution of ~ 100ps. A thickness of the detector together with front-end electronics is ~ 12mm. Results on time resolution…

Gated wires are widely used in Time Projection Chamber (TPC) to avoid ion back-flow (IBF) in the drift volume. The anode wires can provide stable gain at high voltage with a long lifetime. However, switching on and off the gated grid (GG)…

Neutron capture cross-section measurements are fundamental in the study of the slow neutron capture (s-) process of nucleosynthesis and for the development of innovative nuclear technologies. One of the best suited methods to measure…

Accurate momentum determination of a neutral hadron, such as a KL meson or a neutron, remains a significant challenge in particle physics and nuclear physics experiments. The Belle II experiment presents an opportunity to address this…

The barrel time-of-flight detector for the PANDA experiment at FAIR is foreseen as a Scintillator Tile (SciTil) Hodoscope based on several thousand small plastic scintillator tiles read-out with directly attached Silicon Photomultipliers…

We present the CBM physics performance study for measurements of the higher order cumulants of the net-proton multiplicity distributions. These observables are proxy for net-baryon fluctuations and are commonly used to study the phase…

Mass spectrometry is a widespread approach to work out what are the constituents of a material. Atoms and molecules are removed from the material and collected, and subsequently, a critical step is to infer their correct identities based…

A new high-granular compact time-of-flight neutron detector for the identification and energy measurement of neutrons produced in nucleus-nucleus interactions at the BM@N experiment, Dubna, Russia, at energies up to 4 AGeV is under…

Local density fluctuations near the QCD critical point has been suggested to exhibit a power-law behavior which can be probed by an intermittency analysis on scaled factorial moment (SFM) in relativistic heavy-ion collisions. The collision…

Atomic beams are a longstanding technology for atom-based sensors and clocks with widespread use in commercial frequency standards. Here, we report the demonstration a chip-scale microwave atomic beam clock using coherent population…

The analog front-end electronics based on the constant fraction discrimination method is designed and optimized for the Multigap Resistive Plate Chamber (MRPC) timing measurements. The total time resolution of 40 ps has been obtained for 10…

A quantum wavemetry scheme based on the coherence de Broglie wavelength (CBW) is proposed using an M coupled Mach Zehnder interferometer (MZI) architecture to achieve superresolution sensing and metrology. Although CBW does not attain the…

The MicroBooNE liquid argon time projection chamber located at Fermilab is a neutrino experiment dedicated to the study of short-baseline oscillations, the measurements of neutrino cross sections in liquid argon, and to the research and…

The capabilities of the CMS experiment to explore the rich heavy-ion physics programme offered by the CERN Large Hadron Collider (LHC) are summarised. Various representative measurements in Pb-Pb collisions at sqrt(s) = 5.5 TeV are covered.…

The Belle II barrel region is instrumented with the Time of Propagation (TOP) particle identification system based on sixteen fused-silica bars arranged around the interaction point acting as Cherenkov radiator. Due to the mechanical design…

ND280 is a near detector of the T2K experiment which is located in the J-PARC accelerator complex in Japan. After a decade of fruitful data-taking, ND280 is scheduled for upgrade. The time-of-flight (ToF) detector, which is described in…

A calorimetric-time-of-flight (CTOF) technique was used for real-time, high-precision measurement of neutron spectrum at the angle of 175 degrees from the initial proton beam direction, which hits a face plane of a cylindrical iron target…

The CMS experiment is a multi-purpose detector successfully operated at the LHC where predominantly pp collisions take place at various centre-of-mass energies up to sqrt(s)=8 TeV so far. Several weeks per year also heavy-ion collisions…

The prototype of a TDC board has been developed for the new high granular time-of-flight neutron detector (HGND). The board is based on the standard LVDS 4x asynchronous oversampling using the xc7k160 FPGA with a 100 ps bin width. The HGND…