Related papers: Optimal Beamforming and Time Allocation for Partia…

This paper proposes a novel network framework of intelligent reflecting surface (IRS)-assisted simultaneous wireless information and power transfer (SWIPT) non-orthogonal multiple access (NOMA) networks, where IRS is used to enhance the…

Downlink beamforming is an essential technology for wireless cellular networks; however, the design of beamforming vectors that maximize the weighted sum rate (WSR) is an NP-hard problem and iterative algorithms are typically applied to…

The design of Wireless Information and Power Transfer (WIPT) has so far relied on an oversimplified and inaccurate linear model of the energy harvester. In this paper, we depart from this linear model and design WIPT considering the…

Ambient radio frequency (RF) energy harvesting has emerged as a promising solution for powering small devices and sensors in massive Internet of Things (IoT) ecosystem due to its ubiquity and cost efficiency. In this paper, we study joint…

One of the main pervasive problems Wireless Sensor Networks (WSN) encounter is to maintain flawless communication sharing and cooperative processing between sensors via radio links to ensure a reliable treatment of information. Many…

We propose techniques for optimizing transmit beamforming in a full-duplex multiple-input-multiple-output (MIMO) wireless-powered communication system, which consists of two phases. In the first phase, the wireless-powered mobile station…

Physical layer security is a key issue in the full duplex (FD) communication systems due to the broadcast nature of wireless channels. In this paper, the joint design of information and artificial noise beamforming vectors is proposed for…

Distributed antenna systems (DAS) have been widely implemented in state-of-the-art cellular communication systems to cover dead spots. Recent studies have also indicated that DAS have advantages in wireless energy transfer (WET). In this…

Simultaneous wireless information and power transfer (SWIPT) has long been proposed as a key solution for charging and communicating with low-cost and low-power devices. However, the employment of radio frequency (RF) signals for…

One of the main characteristics of Wireless Sensor Networks (WSNs) is the constrained energy resources of their wireless sensor nodes. Although this issue has been addressed in several works and got a lot of attention within the years, the…

Wireless Sensor Networks are basically used for gathering information needed by smart environments but they are particularly useful in unattended situations where terrain, climate and other environmental constraints may hinder in the…

In this paper, we study the waveform design problem for a single-input single-output (SISO) radio-frequency (RF) wireless power transfer (WPT) system in frequency-selective channels. First, based on the actual non-linear current-voltage…

Far-field Wireless Power Transfer (WPT) has emerged as a potential power source for the Internet of Things (IoT) and Wireless Sensor Network (WSN).The expansion of the power transfer range is one of the key challenges to make the technology…

Wireless power transfer (WPT) has garnered increasing attention due to its potential to eliminate device-side batteries. With the advent of (distributed) multiple-input multiple-output (MIMO), radio frequency (RF) WPT has become feasible…

One of the limitations of wireless sensor nodes is their inherent limited energy resource. Besides maximizing the lifetime of the sensor node, it is preferable to distribute the energy dissipated throughout the wireless sensor network in…

Network connectivity is one of the major design issues in the context of mobile sensor networks. Due to diverse communication patterns, some nodes lying in high-traffic zones may consume more energy and eventually die out resulting in…

A multiuser uplink transmission framework based on the segmented waveguide-enabled pinching-antenna system (SWAN) is proposed under two operating protocols: segment selection (SS) and segment aggregation (SA). For each protocol, the…

A cellular multiple-input multiple-output (MIMO) downlink system is studied in which each base station (BS) transmits to some of the users, so that each user receives its intended signal from a subset of the BSs. This scenario is referred…

Simultaneous wireless information and power transfer (SWIPT) is a promising solution to increase the lifetime of wireless nodes and hence alleviate the energy bottleneck of energy constrained wireless networks. As an alternative to…

The optimal resource allocation scheme in a full-duplex Wireless Powered Communication Network (WPCN) composed of one Access Point (AP) and two wireless devices is analyzed and derived. AP operates in a full-duplex mode and is able to…