Related papers: Development of Slow Control Package for the Belle …
BEC-based quantum sensors offer a huge, yet not fully explored potential in gravimetry and ac- celerometry. In this paper, we study a possible setup for such a device, which is a weakly interacting Bose gas trapped in a double-well…
The Silicon Vertex Detector (SVD), with its four double-sided silicon strip sensor layers, is one of the two vertex sub-detectors of Belle II operating at SuperKEKB collider (KEK, Japan). Since 2019 and the start of the data taking, the SVD…
The ALICE experiment at the LHC is equipped with an electromagnetic calorimeter (EMCal) designed to enhance its capabilities for jet, photon and electron measurement. In addition, the EMCal enables triggering on jets and photons with a…
The Compact Linear Collider CLIC is designed to deliver e+e- collisions at a center of mass energy of up to 3 TeV. The detector systems at this collider have to provide highly efficient tracking and excellent jet energy resolution and…
The goal of the KLOE-2 experiment operating at the upgraded DA{\Phi}NE e+e-collider is to collect an integrated luminosity of about 20 fb-1 during 3-4 years of running. Measurements using the KLOE-2 apparatus equipped with the inner…
A timing system provides high-precision signals to allow the controls over a variety of hardware and software components in the accelerator complex. This is guaranteed by the radio frequency (RF) and trigger signal synchronization for…
The ATLAS detector is set to undergo a substantial upgrade termed the "Phase-II" upgrade during the Long-Shutdown in preparation for the start of operation of the High Luminosity Large Hadron Collider (HL-LHC). This paper describes the…
An extended version of the CALICE silicon-tungsten ECAL was tested in November 2021 at the DESY beam test facility. With 15 active layers, it featured some with a thin PCB design, and a new compact DAQ system handling all layers in a common…
Upgrades to the LHCb computing infrastructure in the first long shutdown of the LHC have allowed for high quality decay information to be calculated by the software trigger making a separate offline event reconstruction unnecessary.…
The Belle experiment at the KEKB electron-positron collider is expected to have collected close to one billion $\Upsilon$(4S) events by the time it comes to an end in 2009. An upgrade to KEKB has been proposed. It is designed for an order…
The Compressed Baryonic Matter (CBM) experiment is designed to handle interaction rates of up to 10 MHz and up to 1 TB/s of raw data generated. With triggerless streaming data acquisition in the experiment and beam intensity fluctuations,…
Precision studies of flavour-changing processes involving quarks and leptons provide a number of ways to improve knowledge of the Standard Model and search for physics beyond it. There are excellent short- and mid-term prospects for…
We present two newly constructed experimental setups - REBEL (Resonant Excitation of Beams with Electromagnetic fields and Lasers) and STRIPE (Stopping and Trapping of Radioactive Isotopes for Precision Experiments) - integrated into a…
The BELLE detector has already accumulated e^+ e^- collision data at the KEKB-collider corresponding to 600 fb^-1. BaBar has accumulated data of approximately 390 fb^-1 at PEP-II. Both are running on asymmetric energy e^+ e^- colliders at…
High precision physics at future colliders as the International Linear Collider (ILC) require unprecedented high precision in the determination of the energy of final state particles. The needed precision will be achieved thanks to the…
The working principle and performance of the BELLE particle identification device (PID), based on a hybrid system consisting of an array of high precision scintillator Time of Flight and silica Aerogel Counters, is discussed. The…
Belle II is a rapidly growing collaboration with members from one hundred and nineteen institutes spread around the globe. The software development team of the experiment, as well as the software users, are very much decentralised. Together…
The high design luminosity of the SuperKEKB electron-positron collider will result in challenging levels of beam-induced backgro\ unds in the interaction region. Understanding and mitigating these backgrounds is critical to the success of…
The Source Development Lab (SDL) at BNL consists of a 230 MeV electron linac and a 10 m long wiggler for short wavelength Free Electronic Laser (FEL) development. The original control system [1] was based on the one in use at the National…
The ALICE detector at the LHC (A Large Ion Collider Experiment) will carry out comprehensive measurements of high energy nucleus-nucleus collisions, in order to study QCD matter under extreme conditions and the phase transtion between…