Related papers: The Electronics Design of Error Field Feedback Con…

A new non-disruptive error field (EF) assessment technique not restricted to low density and thus low beta was demonstrated at the EXTRAP-T2R reversed field pinch. Stable and marginally stable external kink modes of toroidal mode number…

We demonstrate the efficient modulation of flux-tunable superconducting resonators (FTRs) using flip-chip or on-chip-based input coils. The FTRs we use are aluminum-based quarter-wave coplanar waveguide resonators terminated with 100um or…

We describe a scheme for quantum error correction that employs feedback and weak measurement rather than the standard tools of projective measurement and fast controlled unitary gates. The advantage of this scheme over previous protocols…

Quantum-dot cellular automata (QCA) is a likely candidate for future low power nano-scale electronic devices. Sequential circuits in QCA attract more attention due to its numerous application in digital industry. On the other hand,…

Programmable control of the inductive electric field enables advanced operations of reversed-field pinch (RFP) plasmas in the Madison Symmetric Torus (MST) device and further develops the technical basis for ohmically heated fusion RFP…

Present state of the art applications in the area of high energy physics experiments (HEP), radar communication, satellite communication and bio medical instrumentation require fault resilient data acquisition (DAQ) system with the data…

PUBLISHED ON IEEE/ASME TRANSACTIONS ON MECHATRONICS, DOI: 10.1109/TMECH.2021.3100150. Ideally, accurate sensor measurements are needed to achieve a good performance in the closed-loop control of mechatronic systems. As a consequence, sensor…

For high-speed quantum key distribution systems, error reconciliation is often the bottleneck affecting system performance. By exchanging common information through a public channel, the identical key can be generated on both communicating…

Electronic systems for qubit control and measurement serve as a bridge between quantum programming language and quantum information processors. With the rapid development of superconducting quantum circuit (SQC) technology, synchronization…

Shanghai Synchrotron Radiation Facility (SSRF), is one of the third-generation high-beam current (3.5 GeV) synchrotron light sources. In the storage ring of SSRF, multi-bunch instabilities would increase beam emittance and energy spread,…

A fully digital beam position and phase measurement (BPPM) system was designed for the linear accelerator (LINAC) in Accelerator Driven Sub-critical System (ADS) in China. Phase information is obtained from the summed signals from four…

Time-digital Converter (TDC) aims to measure the arrival time of the leading edge of the pulse signal. Our recent work presented a high resolution multi-phase TDC based on the Kintex-7 Field Programmable Gate Array (FPGA) device. A simple…

Since some years ago, use of Feedback Control Scheduling Algorithm (FCSA) in the control scheduling co-design of multiprocessor embedded system has increased. FCSA provides Quality of Service (QoS) in terms of overall system performance and…

A field programmable gate array (FPGA) based timing and trigger control system has been developed for the Dynamic Compression Sector (DCS) user facility located at the Advanced Photon Source (APS) at Argonne National Laboratory. The DCS is…

Time to Digital Converters (TDCs) are very common devices in particles physics experiments. A lot of "off-the-shelf" TDCs can be employed but the necessity of a custom DAta acQuisition (DAQ) system makes the TDCs implemented on the…

Optimal control of qubits requires the ability to adapt continuously to their ever-changing environment. We demonstrate a real-time control protocol for a two-electron singlet-triplet qubit with two fluctuating Hamiltonian parameters. Our…

We describe an FPGA-based, 96-channel, time-to-digital converter (TDC) intended for use with the Central Outer Tracker (COT) in the CDF Experiment at the Fermilab Tevatron. The COT system is digitized and read out by 315 TDC cards, each…

Quantum feedback is a technique for measuring a qubit and applying appropriate feedback depending on the measurement results. Here, we propose a new on-chip quantum feedback method where the measurement-result information is not taken from…

Quantum computing architectures rely on classical electronics for control and readout. Employing classical electronics in a feedback loop with the quantum system allows to stabilize states, correct errors and to realize specific…

Load frequency control (LFC) is a key factor to maintain the stable frequency in multi-area power systems. As the modern power systems evolve from centralized to distributed paradigm, LFC needs to consider the peer-to-peer (P2P) based…