Related papers: A readout method based on 10 Gigabit Ethernet for …

We are developing a new readout board with a newer generation field-programmable gate array (FPGA) and the 10-gigabit ethernet to improve the performance and usability of the current readout board based on the 1-gigabit Ethernet. In this…

Due to the advantages of universality, flexibility and high performance, fast Ethernet is widely used in readout system design of modern particle physics experiments. However, Ethernet is usually used together with TCP/IP protocol stack,…

The High Energy Photon Source (HEPS) represents a fourth-generation light source. This facility has made unprecedented advancements in accelerator technology, necessitating the development of new detectors to satisfy physical requirements…

High Energy Physics (HEP) data acquisition systems are often built from high-end FPGAs. As such systems scale in the HL-LHC era, severe under-utilization of FPGA transceivers can occur because front-end links prioritize radiation hardness…

As the Chinese Spallation Neutron Source enters Phase II, the increase in proton beam power will lead to a further boost in the intensity of pulsed neutron beams. To address the demand for higher event-rate readout electronics for…

With the increasing physical event rate and number of electronic channels, traditional readout scheme meets the challenge of improving readout speed caused by the limited bandwidth of crate backplane. In this paper, a high-speed data…

The CMS collaboration is building a new inner tracking pixel detector for the High-Luminosity LHC. Each pixel readout chip will be controlled with a single serial input stream at 160 Mbps and will send out data via four current mode logic…

This work presents the design and preliminary performance of a highly-multiplexed superconducting detector readout. The readout system is implemented on the Xilinx ZCU111 RFSoC Evaluation Board. The current design uses 12% of the DSPs, 60%…

We discuss the performance of a readout system, Fixed Pulse Shape Efficient Readout (FIPSER), to digitize signals from detectors with a fixed pulse shape. In this study we are mainly interested in the readout of fast photon detectors like…

A front-end readout electronics system has been developed for silicon strip detectors. The system uses an application specific integrated circuit (ASIC) ATHED to realize multi-channel E&T measurement. The slow control of ASIC chips is…

We have developed a silicon pixel detector to enhance the physics capabilities of the PHENIX experiment. This detector, consisting of two layers of sensors, will be installed around the beam pipe at the collision point and covers a…

State of the art detector readout electronics require high-throughput data acquisition (DAQ) systems. In many applications, e. g. for medical imaging, the front-end electronics are set up as separate modules in a distributed DAQ. A…

Recent advances in photon detectors have resulted in high-density imaging arrays that offer many performance and cost advantages. In particular, the excellent transit time spread of certain devices show promise to provide tangible benefits…

A scalable readout system (SRS) is designed to provide a general solution for different micro-pattern gas detectors. The system mainly consists of three kinds of modules: the ASIC card, the Adapter card and the Front-End Card (FEC). The…

The average minimum number of bits needed for lossless readout of a pixel detector is calculated, in the regime of interest for particle physics where only a small fraction of pixels have a non-zero value per frame. This permits a…

DEPFET pixel detectors are unique devices in terms of energy and spatial resolution because very low noise (ENC = 2.2e at room temperature) operation can be obtained by implementing the amplifying transistor in the pixel cell itself. Full…

Data breaches and cyberattacks represent a severe problem in higher education institutions and universities that can result in illegal access to sensitive information and data loss. To enhance the security of data transmission, Intrusion…

The SoLid collaboration have developed an intelligent readout system to reduce their 3200 silicon photomultiplier detector's data rate by a factor of 10000 whilst maintaining high efficiency for storing data from anti-neutrino interactions.…

We present the first physical realization of in-pixel signal processing with integrated AI-based data filtering for particle tracking detectors. Building on prior work that demonstrated a physics-motivated edge-AI algorithm suitable for…

Recent years have shown an increased use of silicon photo-multipliers (SiPM) in experiments as they are of reasonable cost, have relatively low power consumption and are easily available in a variety of form factors allowing for a large…