Related papers: Signal Processing Based Pile-up Compensation for G…

Single-shot ptychography is a quantitative phase imaging method wherein overlapping beams of light arranged in a grid pattern simultaneously illuminate a sample, allowing a full ptychographic dataset to be collected in a single shot. It is…

It is not widely appreciated that many subtleties are involved in the accurate measurement of intensity-correlated photons; even for the original experiments of Hanbury Brown and Twiss (HBT). Using a monolithic 4x4 array of single-photon…

The single photoelectron performance characteristics of a Large Area Picosecond PhotoDetector (LAPPD) were studied using a picosecond optical laser source. We verify that the LAPPD is capable of achieving transit time spreads of less than…

We consider the problem of few-viewpoint 3D surface reconstruction using raw measurements from a lidar system. Lidar captures 3D scene geometry by emitting pulses of light to a target and recording the speed-of-light time delay of the…

Improving robotic navigation is critical for extending exploration range and enhancing operational efficiency. Vision-based navigation relying on traditional CCD or CMOS cameras faces major challenges when complex illumination conditions…

We drastically improve the mode overlap between independently seeded, gain-switched laser diodes operating at gigahertz repetition rates by implementing a pulsed light seeding technique. Injecting pulsed light reduces the emission time…

Pile-up signals are frequently produced in experimental physics. They create inaccurate physics data with high uncertainty and cause various problems. Therefore, the correction to pile-up signals is crucially required. In this study, we…

A highly sensitive photodetection system with a detection limit of 1 photon/s was developed. This system uses a commercially available 200-mm-diameter silicon avalanche photodiode (APD) and an in-house-developed ultralow-noise readout…

Hamamatsu Photonics introduced a new generation of their Multi-Pixel Photon Counters in 2013 with significantly reduced after-pulsing rate. In this paper, we investigate the causes of after-pulsing by testing pre-2013 and post-2013 devices…

Silicon sensors with high time resolution can help particle identification in the International Linear Collider (ILC). We are studying Low Gain Avalanche Diodes (LGADs) as a high timing resolution sensor. As a step to develop LGADs, we are…

High dynamic range (HDR) imaging combines multiple images with different exposure times into a single high-quality image. The image signal processing pipeline (ISP) is a core component in digital cameras to perform these operations. It…

Afterpulsing noise in InGaAs/InP single photon avalanche photodiodes (APDs) is caused by carrier trapping and can be suppressed successfully through limiting the avalanche charge via sub-nanosecond gating. Detection of faint avalanches…

Low Gain Avalanche Detectors (LGAD) are based on a n++-p+-p-p++ structure where an appropriate doping of the multiplication layer (p+) leads to high enough electric fields for impact ionization. Gain factors of few tens in charge…

To facilitate high optical coupling efficiency and absorptance, the active area of a superconducting nano/microstrip single-photon detector (SNSPD/SMSPD) is often designed as a meander configuration with a high filling factor (e.g., >=0.5).…

In this contribution, we present an innovative design of the Low-Gain Avalanche Diode (LGAD) gain layer, the p$^+$ implant responsible for the local and controlled signal multiplication. In the standard LGAD design, the gain layer is…

A photon detector combining the two avalanche photon diodes (APD) has been demonstrated for qubit discrimination in 1550 nm. Spikes accompanied with the signals in gated-mode were canceled by balanced output from the two APDs. The spike…

Active imaging systems sample the Transient Light Transport Matrix (TLTM) for a scene by sequentially illuminating various positions in this scene using a controllable light source, and then measuring the resulting spatiotemporal light…

Single-photon LiDAR (SP-LiDAR) simulators face a dilemma: fast but inaccurate Poisson models or accurate but prohibitively slow sequential models. This paper breaks that compromise. We present a simulator that achieves both fidelity and…

Triggered single-photon sources produce the vacuum state with non-negligible probability, but produce a much smaller multiphoton component. It is therefore reasonable to approximate the output of these photon sources as a mixture of the…

Single-Photon Light Detection and Ranging (SP-LiDAR is emerging as a leading technology for long-range, high-precision 3D vision tasks. In SP-LiDAR, timestamps encode two complementary pieces of information: pulse travel time (depth) and…