Related papers: Swift-Link: A compressive beam alignment algorithm…
In this paper, we develop a deep learning (DL)-guided hybrid beam and power allocation approach for multiuser millimeter-wave (mmWave) networks, which facilitates swift beamforming at the base station (BS). The following persisting…
For high-speed train (HST) millimeter wave (mmWave) communications, the use of narrow beams with small beam coverage needs frequent beam switching, while wider beams with small beam gain leads to weaker mmWave signal strength. In this…
Predicting the millimeter wave (mmWave) beams and blockages using sub-6GHz channels has the potential of enabling mobility and reliability in scalable mmWave systems. These gains attracted increasing interest in the last few years. Prior…
Future multi-input multi-output (MIMO) wireless communications systems will use beamforming as a first-step towards realizing the capacity requirements necessitated by the exponential increase in data demands. The focus of this work is on…
Sensor-aided beamforming reduces the overheads associated with beam training in millimeter-wave (mmWave) multi-input-multi-output (MIMO) communication systems. Most prior work, though, neglects the challenges associated with establishing…
The millimeter wave (mmWave) bands have attracted considerable attention for high precision localization applications due to the ability to capture high angular and temporal resolution measurements. This paper explores mmWave-based…
This paper develops a location based analog beamforming (BF) technique using compressive sensing (CS) to be feasible for millimeter wave (mmWave) wireless communication systems. The proposed scheme is based on exploiting the benefits of CS…
Millimeter-wave transceivers use large antenna arrays to form narrow high-directional beams and overcome severe attenuation. Narrow beams require large signaling overhead to be aligned if no prior information about beam directions is…
Millimeter-wave communications rely on narrow-beam transmissions to cope with the strong signal attenuation at these frequencies, thus demanding precise alignment between transmitter and receiver. However, the beam-alignment procedure may…
Initial access at millimeter wave frequencies is a challenging problem due to hardware non-idealities and low SNR measurements prior to beamforming. Prior work has exploited the observation that mmWave MIMO channels are sparse in the…
We propose a deep learning-based method that uses spatial and temporal information extracted from the sub-6GHz band to predict/track beams in the millimeter-wave (mmWave) band. In more detail, we consider a dual-band communication system…
This paper is concerned with the channel estimation problem in Millimeter wave (mmWave) wireless systems with large antenna arrays. By exploiting the inherent sparse nature of the mmWave channel, we first propose a fast channel estimation…
The millimeter-wave (mmWave) communication is envisioned to provide orders of magnitude capacity improvement. However, it is challenging to realize a sufficient link margin due to high path loss and blockages. To address this difficulty, in…
Training sequences are designed to probe wireless channels in order to obtain channel state information for block-fading channels. Optimal training sounds the channel using orthogonal beamforming vectors to find an estimate that optimizes…
Accurate and fast beam-alignment is essential to cope with the fast-varying environment in millimeter-wave communications. A data-driven approach is a promising solution to reduce the training overhead by leveraging side information and…
The requirement of high data-rate in the fifth generation wireless systems (5G) calls for the ultimate utilization of the wide bandwidth in the mmWave frequency band. Researchers seeking to compensate for mmWave's high path loss and to…
We consider a wireless node that randomly receives data from different sensor units. The arriving data must be compressed, stored, and transmitted over a wireless link, where both the compression and transmission operations consume power.…
In this paper, we propose an efficient beam training technique for millimeter-wave (mmWave) communications. When some mobile users are under high mobility, the beam training should be performed frequently to ensure the accurate acquisition…
Millimeter-wave (mmWave) and terahertz (THz) communication systems require large antenna arrays and use narrow directive beams to ensure sufficient receive signal power. However, selecting the optimal beams for these large antenna arrays…
In this paper, we study low-complexity algorithms for beam and channel tracking for millimeter-wave (mmWave) communications. In particular, the least mean squares (LMS) and bidirectional LMS (BiLMS) algorithms are derived for a mobile…