Related papers: Simultaneous measurement of multiple parameters of…

We study the possibility of varying the measured lifetime of a decaying particle based on the technique of weak value amplification in which an additional filtering process called postselection is performed. Our analysis made in a direct…

The implementation of weak-value amplification requires the pre- and post-selection of states of a quantum system, followed by the observation of the response of the meter, which interacts weakly with the system. Data acquisition from the…

Weak values are usually associated with weak measurements of an observable on a pre- and post-selected ensemble. We show that more generally, weak values are proportional to the correlation between two pointers in a successive measurement.…

We experimentally determine weak values for a single photon's polarization, obtained via a weak measurement that employs a two-photon entangling operation, and postselection. The weak values cannot be explained by a semiclassical wave…

We experimentally investigate the relative advantages of implementing weak-value-based metrology versus standard methods. While the techniques outlined herein apply more generally, we measure small optical beam deflections both using a…

Weak values are typically obtained experimentally by performing weak measurements, which involve weak interactions between the measured system and a probe. However, the determination of weak values does not necessarily require weak…

Weak measurements in combination with post-selection can give rise to a striking amplification effect (related to a large "weak value"). We show that this effect can be understood by viewing the initial state of the pointer as the ground…

Weak values and measurements have been proposed as means to achieve dramatic enhancements in metrology based on the greatly increased range of possible measurement outcomes. Unfortunately, the very large values of measurement outcomes occur…

It is often said that measuring a system's position must disturb the complementary property, momentum, by some minimum amount due to the Heisenberg uncertainty principle. Using a "weak-measurement", this disturbance can be reduced. One…

While the novel applications of weak values have recently attracted wide attention, weak measurement, the usual way to extract weak values, suffers from risky approximations and severe quantum noises. In this paper, we show that the…

"Weak measurements" -- involving a weak unitary interaction between a quantum system and a meter followed by a projective measurement -- are investigated when the system has a non-Hermitian Hamiltonian. We show in particular how the…

An experimental scheme is introduced to measure multiple parameters that are encoded in the phase quadrature of a light beam. Using a modal description and a spectrally-resolved homodyne detection, it is shown that all of the information is…

To describe the pre- and post-selected quantum ensembles, a complex quantity called the weak value of an operator is used. The weak value is highly controversial due to the fact that it is not bounded by the possible eigenvalues of the…

Most studies for postselected weak measurement in optomechanical system focus on using a single photon as a measured system. However, we find that using weak coherent light instead of a single photon can also amplify the mirror's position…

It is argued that a weak value of an observable is a robust property of a single pre- and post-selected quantum system rather than a statistical property. During an infinitesimal time a system with a given weak value affects other systems…

Weak measurement [1,19] combined with quantum delayed-choice experiment that use quantum beam splitter instead of the beam splitter give rise to a surprising amplification effect, i.e., counterintuitive negative amplification effect. We…

A weak measurement performed on a pre- and post-selected quantum system can result in an average value that lies outside of the observable's spectrum. This effect, usually referred to as an "anomalous weak value", is generally believed to…

This article primarily aims to unify the various formalisms of multivariate coefficients of variation, leveraging advanced concepts of generalized means, whether weighted or not, applied to the eigenvalues of covariance matrices. We…

We present a parameter estimation technique based on performing joint measurements of a weak interaction away from the weak-value-amplification approximation. Two detectors are used to collect full statistics of the correlations between two…

Weak measurement has been proven to amplify the detection of changes in meters while discarding most photons due to the low probability of post-selection. Previous power-recycling schemes enable the failed post-selection photons to be…