Related papers: Zener Pinning through Coherent Precipitates: A Pha…
We characterize the force state of shear-loaded granular matter by relating the macroscopic stress to statistical properties of the force network. The purely repulsive nature of the interaction between grains naturally provides an upper…
We consider the Bernoulli free boundary problem with ``defects", inhomogeneities in the coefficients of compact support. When the defects are small and arrayed periodically there exist plane-like solutions with a range of large-scale slopes…
We study the impact of a projectile onto a bed of 3 mm grains immersed in an index-matched fluid. Specifically, we vary the amount of prestrain on the sample, strengthening the force chains within the system. We find this affects only the…
A phase-field model for dealing with dynamic instabilities in membranes is presented. We use it to study curvature-driven pearling instability in vesicles induced by the anchorage of amphiphilic polymers on the membrane. Within this model,…
Using piezoresponse force microscopy on epitaxial ferroelectric thin films, we have measured the evolution of domain wall roughening as a result of heat-quench cycles up to 735C, with the effective roughness exponent \zeta\ changing from…
\begin{abstract} We have studied magnetic properties of water-quenched 5 wt.% (Fe, Ti) particle-doped MgB$_2$ comparing with that of air-cooled one. Generally, grain refinement is achieved by increasing cooling rate, which implies an…
We show that a variety of non-monotonic ratchet effects can arise when mesophase pattern-forming systems, which exhibit anisotropic crystal, stripe, and bubble reigmes, are coupled to one-dimensional asymmetric substrates under ac driving.…
We calculate the degree of flux pinning by defects in model high-temperature superconductors (HTSC's). The HTSC is modeled as a three-dimensional network of resistively-shunted Josephson junctions in an external magnetic field,…
The combination of microstructures and mixed wettability for enhancing nucleate boiling has attracted much attention in recent years. However, in the existing experimental and numerical studies, the tops of microstructures are entirely…
We study the linear instability with respect to necking of a filament of polymeric fluid undergoing uniaxial extension. Contrary to the widely discussed Considere criterion, we find the onset of instability to relate closely to the onset of…
Pressure-solution is a chemo-mechanical process, involving dissolution at grain/asperity contacts and precipitation away from them. It induces a compaction in time of rocks and sediments. The present study investigates numerically the…
We solve a coarsening system with small but arbitrary anisotropic surface tension and interface mobility. The resulting size-dependent growth shapes are significantly different from equilibrium microcrystallites, and have a distribution of…
A graded distribution of pinning centers (antidots) in superconducting MoGe thin films has been investigated by magnetization and magneto-optical imaging. The pinning landscape has maximum density at the border, decreasing progressively…
Using density functional tight-binding method, we studied the elastic properties, deformation and failure of armchair (AC) and zigzag (ZZ) phosphorene nano tubes (PNTs) under uniaxial tensile strain. We found that the deformation and…
We consider the process of precipitation in binary alloys in the presence of mechanical deformation. It is commonly observed that mechanical deformation prior to or during precipitation leads to microstructure with excess defects, which…
The finite solid-liquid interface width in phase field models results in non-equilibrium effects, including solute trapping. Prior phase field modeling has shown that this extra degree of freedom, when compared to sharp-interface models,…
This paper presents a combined numerical-theoretical study of the macroscopic behavior and local field distributions in a special class of two-dimensional periodic composites with viscoplastic phases. The emphasis is on strongly nonlinear…
Hydride precipitation in zirconium cladding materials can damage their integrity and durability.Service temperature and material defects have a significant effect on the dynamic growth of hydrides. In this study, we have developed a phase…
The spreading of liquid drops on surfaces corrugated with micron-scale parallel grooves is studied both experimentally and numerically. Because of the surface patterning, the typical final drop shape is no longer spherical. The elongation…
A vertically graded anisotropy profile has been proposed as an optimized balance of low coercivity and thermal stability for multilayers used in magnetic media. Deposition pressure is known to have a profound effect on the magnetic reversal…