Related papers: MIMO radar waveform design with practical constrai…
Achieving high channel estimation accuracy and reducing hardware cost as well as power dissipation constitute substantial challenges in the design of massive multiple-input multiple-output (MIMO) systems. To resolve these difficulties,…
We present the design and hardware implementation of a radar prototype that demonstrates the principle of a sub-Nyquist collocated multiple-input multiple-output (MIMO) radar. The setup allows sampling in both spatial and spectral domains…
A MIMO radar system is proposed for obtaining angle and Doppler information on potential targets. Transmitters and receivers are nodes of a small scale wireless network and are assumed to be randomly scattered on a disk. The transmit nodes…
Hybrid digital/analog architecture and low-resolution analog-to-digital/digital-to-analog converters (ADCs /DACs) are two low-cost implementations for large-scale millimeter wave (mmWave) systems. In this paper, we investigate the problem…
In this paper, we consider the delay-constrained beamforming control for downlink multi-user MIMO (MU- MIMO) systems with imperfect channel state information at the transmitter (CSIT). The delay-constrained control problem is formulated as…
Dual-functional radar-communication (DFRC) signal design has received much attention lately. We consider the scenario of one-bit massive multi-input multi-output (MIMO) wherein one-bit DACs are employed for the sake of saving hardware…
Hybrid beamforming is an emerging technology for massive multiple-input multiple-output (MIMO) systems due to the advantages of lower complexity, cost, and power consumption. Recently, intelligent reflection surface (IRS) has been proposed…
Multiple-input multiple-output (MIMO) radars transmit a set of sequences that exhibit small cross-correlation sidelobes, to enhance sensing performance by separating them at the matched filter outputs. The waveforms also require small…
The large beamforming gain used to operate at millimeter wave (mmWave) frequencies requires obtaining channel information to configure hybrid antenna arrays. Previously proposed wideband channel estimation strategies, however, assume…
We analyze a multiple-input multiple-output (MIMO) radar model and provide recovery results for a compressed sensing (CS) approach. In MIMO radar different pulses are emitted by several transmitters and the echoes are recorded at several…
In this paper, the pilot signal design for massive MIMO systems to maximize the training-based received signal-to-noise ratio (SNR) is considered under two channel models: block Gauss-Markov and block independent and identically distributed…
This paper tackles the problem of joint active and passive beamforming optimization for an intelligent reflective surface (IRS)-assisted multi-user downlink multiple-input multiple-output (MIMO) communication system. We aim to maximize…
An efficient beamforming design is proposed for continuous aperture array (CAPA)-based point-to-point multiple-input multiple-output (MIMO) systems. In contrast to conventional spatially discrete array (SPDA)-MIMO systems, whose optimal…
This paper studies a novel approach for successive interference cancellation (SIC) ordering and beamforming in a multiple antennas non-orthogonal multiple access (NOMA) network with multi-carrier multi-user setup. To this end, we formulate…
In this paper, we propose new operator-splitting algorithms for the total variation regularized infimal convolution (TV-IC) model [4] in order to remove mixed Poisson-Gaussian(MPG) noise. In the existing splitting algorithm for TV-IC, an…
In this letter, the achievable rate maximization problem is considered for intelligent reflecting surface (IRS) assisted multiple-input multiple-output (MIMO) systems in an underlay spectrum sharing scenario, subject to interference power…
The optimization of the transmit parameters (power allocation and steering vectors) for the MIMO BC under general linear constraints is treated under the optimal DPC coding strategy and the simple suboptimal linear zero-forcing beamforming…
We introduce a revised derivation of the bitwise Markov Chain Monte Carlo (MCMC) multiple-input multiple-output (MIMO) detector. The new approach resolves the previously reported high SNR stalling problem of MCMC without the need for…
This paper proposes block-level precoder (BLP) designs for a multi-input single-output (MISO) system that performs joint sensing and communication across multiple cells and users. The Cramer-Rao-Bound for estimating a target's azimuth angle…
Due to their ability to create favorable line-of-sight (LoS) propagation environments, intelligent reflecting surfaces (IRSs) are regarded as promising enablers for future millimeter-wave (mm-wave) wireless communication. In this paper, we…