Related papers: Optimization of the pulse width and injection time…
We report on an Yb:YAG thin-disk multipass amplifier delivering 50 ns long pulses at a central wavelength of 1030 nm with an energy of 330 mJ at a repetition rate of 100 Hz. The beam quality factor at the maximum energy was measured to be…
We describe an efficient laser emission from a directly grown Er3+:YAG single-crystal fiber that is resonantly pumped using a continuous-wave (CW) laser diode at 1532 nm. In a longitudinal pumping, it emits 12.5 W at 1645 nm with a slope…
We report a multi-microjoule, ultra-broadband mid-infrared optical parametric amplifier based on a GaSe nonlinear crystal pumped at ~2 {\mu}m. The generated idler pulse has a flat spectrum spanning from 4.5 to 13.3 {\mu}m at -3 dB and 4.2…
A way to considerably enhance terahertz radiation, emitted in the interaction of intense mid-infrared laser pulses with atomic gases, in both the total energy and the electric-field amplitude is suggested. The scheme is based on the…
With increasing laser peak power, the generation and manipulation of high-power laser pulses becomes a growing challenge for conventional solid-state optics due to their limited damage threshold. As a result, plasma-based optical components…
Spatially combining multiple strong laser beams is a promising concept for achieving ultrahigh laser intensities. Proof-of-principle experiments have been conducted at the National Ignition Facility to report a combination of up to twenty…
In the context of the Lamb shift measurement in muonic helium we developed a thin-disk laser composed of a Q-switched oscillator and a multi-pass amplifier delivering pulses of 150 mJ at a pulse duration of 100 ns. Its peculiar requirements…
In this article, we derive analytically the complex optical spectrum of a pulsed laser source obtained when a frequency comb generated by phase modulation is input into a synchronized intensity modulator. We then show how this knowledge of…
We report a new type of vulnerability in practical implementations of quantum key distribution systems. We show that it is possible to increase the pulse energy of a source laser diode not only by injection-locking it by external light near…
As Ultrafast laser technology advances towards ever higher peak and average powers, generating sub-50 fs pulses from laser architectures that exhibit best power-scaling capabilities remains a major challenge. Here, we present a very compact…
In this paper, laser pulses with pulse-widths approach to the round-trip time are generated by utilizing a cavityless high gain Nd:GdVO4 bounce geometry. By adopting an EOQ (electro-optics Q-switch), pulse-widths of 1.36 ns, 1.82 ns, and…
A thulium-doped fiber laser operating quasi-continuous-wave generated 198 W of instantaneous output power in 0.2-ms pulses at 50 Hz repetition rate. The duty cycle becomes 1% and the average output power 2.0 W. This was cladding-pumped with…
Ultra-short high-power lasers can deliver extreme light intensities ($\ge 10^{20}$ W/cm$^2$ and $\leq 30 f$s) and drive large amplitude Surface Plasma Wave (SPW) at over-dense plasma surface. The resulting current of energetic electron has…
Optical quadratic nonlinearity is ultrafast in nature, while parametric interaction usually manifests only the broadband characteristic. Enormous progress has been made toward broadband phase-matching for parametric amplification and wide…
We demonstrate efficient pulse-energy extraction from a partly-quenched erbium-doped aluminosilicate fiber amplifier. This has a high erbium-concentration, which allows for short devices with reduced nonlinear distortions, but which also…
We explore parabolic pre-shaping as a means of generating and amplifying ultrashort pulses. We develop a theoretical framework for modeling the technique and use its conclusions to design a femtosecond fiber amplifier. Starting from 9 ps…
In this study we explore the optimization of laser pulse duration to obtain the shortest possible pulse. We do this by employing a feedback loop between a pulse shaper and pulse duration measurements. We apply to this problem several…
We report a room-temperature diode-pumped solid-state laser by water immersion cooling, which delivers a pulse energy of 11 J at the repetition rate of 100 Hz and the pulse duration of 7 ns, while the beam quality factor is 2.6 times the…
The ablation of solid tin surfaces by an 800-nanometer-wavelength laser is studied for a pulse length range from 500 fs to 4.5 ps and a fluence range spanning 0.9 to 22 J/cm^2. The ablation depth and volume are obtained employing a…
A new amplification method based on the optical Kerr instability is suggested and theoretically analyzed, with emphasis on the near to mid-infrared wavelength regime. Our analysis for CaF2 and KBr crystals shows that one to two cycle pulse…