Related papers: Single-User mmWave Massive MIMO: SVD-based ADC Bit…

Modern communication receiver architectures center around digital signal processing (DSP), with the bulk of the receiver processing being performed on digital signals obtained after analog-to-digital conversion (ADC). In this paper, we…

This paper considers the joint transceiver design for downlink multiuser multiple-input single-output (MISO) systems with coordinated base stations (BSs) where imperfect channel state information (CSI) is available at the BSs and mobile…

Channel estimation at millimeter wave (mmWave) is challenging when large antenna arrays are used. Prior work has leveraged the sparse nature of mmWave channels via compressed sensing based algorithms for channel estimation. Most of these…

This letter revisits the channel estimation problem for MIMO systems with one-bit analog-to-digital converters (ADCs) through a novel algorithm--Amplitude Retrieval (AR). Unlike the state-of-the-art methods such as those based on one-bit…

This paper addresses the problem of uplink transmit power optimization in distributed massive multiple-input multiple-output systems, where remote radio heads (RRHs) are equipped with 1-bit analog-to-digital converters (ADCs). First, in a…

In this work, we consider the acquisition of stationary signals using uniform analog-to-digital converters (ADCs), i.e., employing uniform sampling and scalar uniform quantization. We jointly optimize the pre-sampling and reconstruction…

We study the multi-user massive multiple-input-single-output (MISO) and focus on the downlink systems where the base station (BS) employs hybrid analog-digital precoding with low-cost 1-bit digital-to-analog converters (DACs). In this…

Hybrid precoder and combiner designs are conceived for decentralized parameter estimation in millimeter wave (mmWave) multiple-input multiple-output (MIMO) wireless sensor networks (WSNs). More explicitly, efficient pre- and post-processing…

A potential tremendous spectrum resource makes millimeter wave (mmWave) communications a promising technology. High power consumption due to a large number of antennas and analog-to-digital converters (ADCs) for beamforming to overcome the…

The potential of deploying large-scale antenna arrays in future wireless systems has stimulated extensive research on hybrid transceiver designs aiming to approximate the optimal fully-digital schemes with much reduced hardware cost and…

We investigate full-duplex (FD) multi-user multiple input single-output systems with coarse quantization, aiming to characterize the impact of employing low-resolution analog-to-digital converters (ADCs) on self-interference (SI) and to…

This paper develops a new deep neural network optimized equalization framework for massive multiple input multiple output orthogonal frequency division multiplexing (MIMOOFDM) systems that employ low-resolution analog-to-digital converters…

We consider channel estimation for an uplink massive multiple-input multiple-output (MIMO) system where the base station (BS) uses an array with low-resolution (1-2 bit) analog-to-digital converters and a spatial Sigma-Delta…

Multi-cell coordinated beamforming (MCBF), where multiple base stations (BSs) collaborate with each other in the beamforming design for mitigating the inter-cell interference, has been a subject drawing great attention recently. Most MCBF…

Future communication system requires large bandwidth to achieve high data rate up to multigigabit/ sec, which makes analog-to-digital (ADC) become a key bottleneck for the implementation of digital receivers due to its high complexity and…

Massive multiple-input multiple-output (MIMO) can improve the overall system performance significantly. Massive MIMO systems, however, may require a large number of radio frequency (RF) chains that could cause high cost and power…

All-digital millimeter-wave (mmWave) massive multi-user multiple-input multiple-output (MU-MIMO) receivers enable extreme data rates but require high power consumption. In order to reduce power consumption, this paper presents the first…

Millimeter wave (mmWave) spectrum has drawn attention due to its tremendous available bandwidth. The high propagation losses in the mmWave bands necessitate beamforming with a large number of antennas. Traditionally each antenna is paired…

This paper focuses on channel estimation in single-user and multi-user MIMO systems with multi-antenna base stations equipped with 1-bit spatial sigma-delta analog-to-digital converters (ADCs). A careful selection of the quantization…

Massive multiple-input multiple-output (MIMO) is a key technology for 5G wireless communications with a promise of significant capacity increase. The use of low-resolution data converters is crucial for massive MIMO to make the overall…