Related papers: Necking instabilities in elasto-viscoplastic mater…
The shear-transformation-zone (STZ) theory of plastic deformation predicts that sufficiently soft, non-crystalline solids are linearly unstable against forming periodic arrays of microstructural shear bands. A limited nonlinear analysis…
Voids can limit the life of engineering components. This motivates us to understand local plasticity around voids in a nickel base superalloy combining experiments and simulations. Single crystal samples were deformed in tension with…
Nematic elastomers are rubbery solids which have liquid crystals incorporated into their polymer chains. These materials display many unusual mechanical properties, one such being the ability to form fine-scale microstructure. In this work,…
A mesoscopic model for shear plasticity of amorphous materials in two dimensions is introduced, and studied through numerical simulations in order to elucidate the macroscopic (large scale) mechanical behavior. Plastic deformation is…
When far from equilibrium, many-body systems display behavior that strongly depends on the initial conditions. A characteristic such example is the phenomenon of plasticity of crystalline and amorphous materials that strongly depends on the…
Self-positioned nanomembranes such as rolled-up tubes and wrinkled thin films have been potential systems for a variety of applications and basic studies on elastic properties of nanometer-thick systems. Although there is a clear driving…
The modeling of the elastic properties of disordered or nanoscale solids requires the foundations of the theory of elasticity to be revisited, as one explores scales at which this theory may no longer hold. The only cases for which…
Electro-hydrodynamic phenomena in liquid crystals constitute an old but still very active research area. The reason is that these phenomena play the key role in various applications of liquid crystals and due to the general interest of…
In this paper we consider and generalize a model, recently proposed and analytically investigated in its quasi-stationary approximation by the authors, for visco-elasticity with large deformations and conditional compatibility, where the…
We analyze stability of the planar orientational structure in a nematic liquid crystal (NLC) cell with planar anchoring conditions at both substrates. Specifically, we study the instabilities of the ground state caused by surface elasticity…
Amorphization during severe plastic deformation has been observed in various crystalline materials, yet its underlying mechanisms remain poorly understood. This study introduces a novel phase-field model at the mesoscale, integrating…
We investigate the finite bending and the associated bending instability of an incompressible dielectric slab subject to a combination of applied voltage and axial compression, using nonlinear electro-elasticity theory and its incremental…
Most, but not all, liquid crystals tend to align when subject to shear flow, while most nematic polymeric liquid crystals undergo a tumbling instability, where the director rotate with the flow. The reasons of this instability remain…
The transition between necking-mediated tensile failure of glasses, at elevated temperatures and/or low strain-rates, and shear-banding-mediated tensile failure, at low temperatures and/or high strain-rates, is investigated using tensile…
Under compressive creep, visco-plastic solids experiencing internal mass transfer processes have been recently proposed to accommodate singular cnoidal wave solutions, as material instabilities at the stationary wave limit. These…
Elucidating the interplay of defect and stress at the microscopic level is a fundamental physical problem that has strong connection with materials science. Here, based on the two-dimensional crystal model, we show that the instability mode…
Electrostatic theory preserves charges, but allows dipolar excitations. Elasticity theory preserves dipoles, but allows quadrupolar (Eshelby like) plastic events. Charged amorphous granular systems are interesting in their own right; here…
Mechanical densification of granular bodies is a process in which a loose material becomes increasingly cohesive as the applied pressure increases. A constitutive description of this process faces the formidable problem that granular and…
Partially wetting nematic liquid crystal (NLC) films on substrates are unstable to dewetting-type instabilities due to destablizing solid/NLC interaction forces. These instabilities are modified by the nematic nature of the films, which…
We investigate a minimal model of the plastic deformation of amorphous materials. The material elements are assumed to exhibit ideally plastic behavior (J2 plasticity). Structural disorder is considered in terms of random variations of the…