Related papers: Digital Predistortion for Hybrid MIMO Transmitters
Consider a MIMO interference channel whereby each transmitter and receiver are equipped with multiple antennas. The basic problem is to design optimal linear transceivers (or beamformers) that can maximize system throughput. The recent work…
Dynamic metasurface antennas (DMAs) are emerging as a promising technology to enable energy-efficient, large array-based multi-antenna systems. This paper presents a simple channel estimation scheme for the downlink of a multiple-input…
We present deep learning methods for the design of arrays and single instances of small antennas. Each design instance is conditioned on a target radiation pattern and is required to conform to specific spatial dimensions and to include, as…
We consider a general spectral coexistence scenario, wherein the channels and transmit signals of both radar and communications systems are unknown at the receiver. In this \textit{dual-blind deconvolution} (DBD) problem, a common receiver…
In this paper, we consider the problem of iterative detection and decoding (IDD) for multi-antenna systems using low-density parity-check (LDPC) codes. The proposed IDD system consists of a soft-input soft-output parallel interference (PIC)…
Robust beamforming design under imperfect channel state information (CSI) is a fundamental challenge in multiuser multiple-input multiple-output (MU-MIMO) systems, particularly when the channel estimation error statistics are unknown.…
This work focuses on designing a power-efficient network for Dynamic Metasurface Antennas (DMA)-aided multi-user multiple-input single-output (MISO) antenna systems. Power efficiency is achieved through holographic beamforming in a…
In future B5G/6G broadband communication systems, non-linear signal distortion caused by the impairment of transmit power amplifier (PA) can severely degrade the communication performance, especially when uplink users share the wireless…
This paper considers a lens antenna array-assisted millimeter wave (mmWave) multiuser multiple-input multiple-output (MU-MIMO) system. The base station's beam selection matrix and user terminals' phase-only beamformers are jointly designed…
A simple method is proposed for use in a scenario involving a single-antenna source node communicating with a destination node that is equipped with two antennas via multiple single-antenna relay nodes, where each relay is subject to an…
The superimposed pilot transmission scheme offers substantial potential for improving spectral efficiency in MIMO-OFDM systems, but it presents significant challenges for receiver design due to pilot contamination and data interference. To…
The 3GPP suggests to combine dual polarized (DP) antenna arrays with the double directional (DD) channel model for downlink channel estimation. This combination strikes a good balance between high-capacity communications and parsimonious…
Nonlinear distortion stemming from low-cost power amplifiers may severely affect wireless communication performance through out-of-band (OOB) radiation and in-band distortion. The distortion is correlated between different transmit antennas…
In massive multiple-input multiple-output (MIMO) systems, hybrid analog-digital beamforming is an essential technique for exploiting the potential array gain without using a dedicated radio frequency chain for each antenna. However, due to…
Full-dimensional (FD) multi-user massive multiple input multiple output (m-MIMO) systems employ large two-dimensional (2D) rectangular antenna arrays to control both the azimuth and elevation angles of signal transmission. We introduce the…
We consider a multi-user (MU) full-duplex (FD) multiple-input multiple-output (MIMO) communication system, in which the base station transceiver is equipped with transmit and receive position reconfigurable antennas (PRAs) to mitigate both…
This paper proposed new hybrid, analog-digital, beamforming for a multiuser millimeter wave (mm-wave) relay system. For this system, we consider a sum rate maximization problem. The proposed hybrid beamforming is designed indirectly by…
Sensing the direction of arrival and polarization of impinging signals is a key prerequisite for beamforming and interference mitigation in modern wireless communication systems. Dynamic metasurface antennas (DMAs) can multiplex direction-…
Full-duplex (FD) systems have the capability to transmit and receive at the same time in the same frequency band. FD systems can reduce congestion and latency and improve coverage and spectral efficiency. As a relay, they can increase range…
Dynamic metasurface antennas (DMAs) provide a new paradigm to realize large-scale antenna arrays for future wireless systems. In this paper, we study the downlink millimeter wave (mmWave) DMA systems with limited number of radio frequency…