Related papers: Message passing-based joint CFO and channel estima…
Training beam design for channel estimation with infinite-resolution and low-resolution phase shifters (PSs) in hybrid analog-digital milimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems is considered in this paper.…
Accurate channel estimation is essential for achieving the performance gains offered by reconfigurable intelligent surface (RIS)-aided wireless communications. A variety of channel estimation methods have been proposed for such systems;…
The acquisition of channel state information (CSI) is essential in MIMO-OFDM communication systems. Data-aided enhanced receivers, by incorporating domain knowledge, effectively mitigate performance degradation caused by imperfect CSI,…
The high path loss associated with millimeter wave (mmWave) frequency communication can be compensated by large scale antenna arrays such as multiple-input multiple-output (MIMO) systems. The hybrid beamforming architecture which uses fewer…
Given the high degree of computational complexity of the channel estimation technique based on the conventional one-dimensional (1-D) compressive sensing (CS) framework employed in the hybrid beamforming architecture, this study proposes…
In this paper, channel estimation for millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems with one-bit analog-to-digital converters (ADCs) is considered. In the mmWave band, the number of propagation paths is…
This paper focuses on channel estimation in single-user and multi-user MIMO systems with multi-antenna base stations equipped with 1-bit spatial sigma-delta analog-to-digital converters (ADCs). A careful selection of the quantization…
Multiple carrier-frequency offsets (CFO) arise in a distributed antenna system, where data are transmitted simultaneously from multiple antennas. In such systems the received signal contains multiple CFOs due to mismatch between the local…
Channel acquisition is one of the main challenges for the deployment of reconfigurable intelligent surface (RIS) aided communication systems. This is because an RIS has a large number of reflective elements, which are passive devices with…
Millimeter-wave (mmWave) communication in combination with massive multiuser multiple-input multiple-output (MU-MIMO) enables high-bandwidth data transmission to multiple users in the same time-frequency resource. The strong path loss of…
In this work, the uplink channel estimation problem is considered for a millimeter wave (mmWave) multi-input multi-output (MIMO) system. It is well known that pilot overhead and computation complexity in estimating the channel increases…
Oscillator phase noise (PHN) and carrier frequency offset (CFO) can adversely impact the performance of orthogonal frequency division multiplexing (OFDM) systems, since they can result in inter carrier interference and rotation of the…
In this work, we address the problem of estimating sparse communication channels in OFDM systems in the presence of carrier frequency offset (CFO) and unknown noise variance. To this end, we consider a convex optimization problem, including…
Millimeter-wave (mmWave) channels, which occupy frequency ranges much higher than those being used in previous wireless communications systems, are utilized to meet the increased throughput requirements that come with 5G communications. The…
In this work, we address the problem of channel estimation and precoding / combining for the so-called hybrid millimeter wave (mmWave) MIMO architecture. Our proposed channel estimation scheme exploits channel reciprocity in TDD MIMO…
As a key technology to meet the ever-increasing data rate demand in beyond 5G and 6G communications, millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems have gained much attention recently.To make the most of…
Millimeter-wave (mmWave) communications have been one of the promising technologies for future wireless networks that integrate a wide range of data-demanding applications. To compensate for the large channel attenuation in mmWave band and…
The use of low precision (e.g., 1-3 bits) analog-to-digital convenors (ADCs) in very large multiple-input multiple-output (MIMO) systems is a technique to reduce cost and power consumption. In this context, nevertheless, it has been shown…
This paper presents a novel algorithm for residual phase estimation in wireless OFDM systems, including the carrier frequency offset (CFO) and the sampling frequency offset (SFO). The subcarriers are partitioned into several regions which…
Millimeter-wave (mmWave) massive Multiple Input Multiple Output (MIMO) systems encounter both spatial wideband spreading and temporal wideband effects in the communication channels of individual users. Accurate estimation of a user's…