Related papers: Iterative Turbo Receiver for LDPC-Coded MIMO Syste…
Linear receivers are an attractive low-complexity alternative to optimal processing for multi-antenna MIMO communications. In this paper we characterize the information-theoretic performance of MIMO linear receivers in two different…
In this paper, we have investigated the application of non-binary LDPC codes to spatial multiplexing MIMO systems with a large number of low power antennas. We demonstrate that such large MIMO systems incorporating with low-complexity MMSE…
A multiple input, multiple output (MIMO) radar emits probings signals with multiple transmit antennas and records the reflections from targets with multiple receive antennas. Estimating the relative angles, delays, and Doppler shifts from…
This paper proposes a relay selection scheme that aims to improve the end-to-end symbol error rate (SER) performance of a two-way relay network (TWRN). The TWRN consists of two single-antenna sources and multiple relays employing…
This work considers optimizing LDPC codes in the physical-layer network coded two-way relay channel using noncoherent FSK modulation. The error-rate performance of channel decoding at the relay node during the multiple-access phase was…
Kudekar et al. proved that the belief-propagation (BP) performance for low-density parity check (LDPC) codes can be boosted up to the maximum-a-posteriori (MAP) performance by spatial coupling. In this paper, spatial coupling is applied to…
In this paper, we consider a dual-hop Multiple Input Multiple Output (MIMO) relay wireless network, in which a source-destination pair both equipped with multiple antennas communicates through a large number of half-duplex…
The use of one-bit analog-to-digital converters (ADCs) is a practical solution for reducing cost and power consumption in massive Multiple-Input-Multiple-Output (MIMO) systems. However, the distortion caused by one-bit ADCs makes the data…
Software Defined Radio (SDR) platforms are valuable for research and development activities or high-end systems that demand real-time adaptable wireless protocols. While low latency can be achieved using the dedicated digital processing…
Next-generation communication systems with wide bandwidths need to operate in interference-limited networks. A discrete-time delay (TD) technique in a baseband receiver array is proposed for canceling wide modulated bandwidth spatial…
Iterative decoders used for decoding low-density parity-check (LDPC) and moderate-density parity-check (MDPC) codes are not characterized by a deterministic decoding radius and their error rate performance is usually assessed through…
In this paper, we propose a novel splitting receiver, which involves joint processing of coherently and non-coherently received signals. Using a passive RF power splitter, the received signal at each receiver antenna is split into two…
In this paper, a novel transceiver architecture is proposed to simultaneously achieve efficient random access and reliable data transmission in massive IoT networks. At the transmitter side, each user is assigned a unique protocol sequence…
The error floor phenomenon observed with LDPC codes and their graph-based, iterative, message-passing (MP) decoders is commonly attributed to the existence of error-prone substructures -- variously referred to as near codewords, trapping…
We propose an iterative decoding method, which we call turbo-CS, for the reception of concatenated source-channel encoded sparse signals transmitted over an AWGN channel. The turbo-CS encoder applies 1-bit compressed sensing as a source…
This is the second part of a two-part paper that focuses on link-adaptation (LA) and physical layer (PHY) abstraction for multi-user MIMO (MU-MIMO) systems with non-linear receivers. The first part proposes a new metric, called bit-metric…
In fact, the broadcast nature of every transmitter makes it possible for other transceivers in the channel to overhear the broadcasted signal. The proposed idea in cooperative communication is to use these intermediate transceivers as relay…
Much stringent reliability and processing latency requirements in ultra-reliable-low-latency-communication (URLLC) traffic make the design of linear massive multiple-input-multiple-output (M-MIMO) receivers becomes very challenging.…
Generalized spatial modulation-aided affine frequency division multiplexing (GSM-AFDM) is conceived for reliable multiple-input multiple-output (MIMO) communications over doubly selective channels. \textcolor{black}{We commence by proposing…
Iterative probabilistic inference, popularly dubbed the soft-iterative paradigm, has found great use in a wide range of communication applications, including turbo decoding and turbo equalization. The classic approach of analyzing the…