Related papers: One-bit massive MIMO precoding via a minimum symbo…
Internet-of-Things (IoT) refers to a high-density network of low-cost low-bitrate terminals and sensors where also low energy consumption is one central feature. As the power-budget of classical receiver chains is dominated by the…
The fundamental limits of communication over multiple-input multiple-output (MIMO) networks are considered when a limited number of one-bit analog to digital converters (ADC) are used at the receiver terminals. Prior works have mainly…
By processing in the frequency domain (FD), massive MIMO systems can approach the theoretical per-user capacity using a single carrier modulation (SCM) waveform with a cyclic prefix. Minimum mean squared error (MMSE) detection and zero…
The practical utilization of the symbol-level precoding in MIMO systems is challenging since the implementation of the sophisticated optimization algorithms must be done with reasonable computational resources. In the real implementation of…
Massive multi-input multiple-out (MIMO) is a key ingredient in improving the spectral efficiencies for next-generation cellular systems. Thanks to the channel reciprocity, in time-division-duplexing mode, each base station (BS) can acquire…
In multi-user millimeter wave (mmWave) multiple-input-multiple-output (MIMO) systems, hybrid precoding is a crucial task to lower the complexity and cost while achieving a sufficient sum-rate. Previous works on hybrid precoding were usually…
The problem of 1-bit compressive sampling is addressed in this paper. We introduce an optimization model for reconstruction of sparse signals from 1-bit measurements. The model targets a solution that has the least l0-norm among all signals…
We study the performance of the simulated bifurcation (SB) algorithm for signal detection in multiple-input multiple-output (MIMO) system, a problem of key interest in modern wireless communication systems. Our results show that SB…
This paper proposes novel pilot optimization and channel estimation algorithm for the downlink multiuser massive multiple input multiple output (MIMO) system with $K$ decentralized single antenna mobile stations (MSs), and time division…
We develop a method to jointly estimate the carrier frequency offset (CFO) and the narrowband channel in millimeter wave (mmWave) MIMO systems operating with one-bit analog-to-digital converters (ADCs). We assume perfect timing…
A family of low-complexity detection schemes based on channel matrix puncturing targeted for large multiple-input multiple-output (MIMO) systems is proposed. It is well-known that the computational cost of MIMO detection based on QR…
Low-complexity precoding {algorithms} are proposed in this work to reduce the computational complexity and improve the performance of regularized block diagonalization (RBD) {based} precoding {schemes} for large multi-user {MIMO} (MU-MIMO)…
In this work, we consider Terahertz (THz) communications with low-resolution uniform quantization and spatial oversampling at the receiver side, corresponding to a single-input multiple-output (SIMO) transmission. We fairly compare…
This paper presents a low-complexity near-maximum-likelihood-detection (near-MLD) algorithm called one-bit-sphere-decoding for an uplink massive multiple-input multiple-output (MIMO) system with one-bit analog-to-digital converters (ADCs).…
Hybrid analog/digital precoding in millimeter-wave (mmWave) multi-input multi-ouput (MIMO) systems is capable of achieving the near-optimal full-digital performance at reduced hardware cost and power consumption compared to its full-RF…
This article presents a differential detection scheme for the uplink of a massive MIMO system that employs one-bit quantizers on each receive antenna. We focus on the detection of differential amplitude and phase shift keying symbols and we…
This paper investigates the linear precoder design for $K$-user interference channels of multiple-input multiple-output (MIMO) transceivers under finite alphabet inputs. We first obtain general explicit expressions of the achievable rate…
This paper considers a multi-user multiple-input multiple-output (MU-MIMO) system where the precoding matrix is selected in a baseband unit (BBU) and then sent over a digital fronthaul to the transmitting antenna array. The fronthaul has a…
A channel with continuous phase modulation and 1-bit ADC with oversampling is considered. Due to oversampling, higher-order modulations yield a higher achievable rate and this work presents a method to approach this with sophisticated…
In this paper, we aim to design highly energy efficient end-to-end communication for millimeter wave multiple-input multiple-output systems. This is done by jointly optimizing the digital-to-analog converter (DAC)/analog-to-digital…