Related papers: Genetic Algorithm Assisted Hybrid Beamforming for …
In this letter, we investigate the hybrid beamforming for millimeter wave massive multiple-input multiple-output (MIMO) system based on deep reinforcement learning (DRL). Imperfect channel state information (CSI) is assumed to be available…
Millimeter-wave (mmWave) communication is considered as an indispensable technique for the next-generation backhaul/fronthaul network thanks to its large transmission bandwidth. Especially for heterogeneous network (HetNet), the mmWave…
Hybrid beamforming is known to be a cost-effective and wide-spread solution for a system with large-scale antenna arrays. This work studies the optimization of the analog and digital components of the hybrid beamforming solution for remote…
This work gives a blind beamforming strategy for intelligent reflecting surface (IRS), aiming to boost the received signal-to-noise ratio (SNR) by coordinating phase shifts across reflective elements in the absence of channel information.…
In this paper, a hybrid IRS-aided amplify-and-forward (AF) relay wireless network is put forward, where the hybrid IRS is made up of passive and active elements. For maximum signal-to-noise ratio (SNR), a low-complexity method based on…
This paper presents a robust beam alignment technique for millimeter-wave communications in low signal-to-noise ratio (SNR) environments. The core strategy of our technique is to repeatedly transmit the most probable beam candidates to…
Hybrid analog-digital precoding is a key millimeter wave access technology, where an antenna array with reduced number of radio frequency (RF) chains is used with an RF precoding matrix to increase antenna gain at a reasonable cost.…
In this paper, we focus on the phenomenon of beam misalignment in Millimeter-wave (mmWave) multi-receiver communication systems, and propose robust hybrid precoding designs that alleviate the performance loss caused by this effect. We…
Millimeter-wave (mmWave) technology is one of the most promising candidates for future wireless communication systems as it can offer large underutilized bandwidths and eases the implementation of large antenna arrays which are required to…
We propose a learning-based method for the joint design of a transmit and receive filter, the constellation geometry and associated bit labeling, as well as a neural network (NN)-based detector. The method maximizes an achievable…
Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…
Antenna arrays will be an important ingredient in millimeter wave (mmWave) cellular systems. A natural application of antenna arrays is simultaneous transmission to multiple users. Unfortunately, the hardware constraints in mmWave systems…
In this letter, we aim to design a robust hybrid precoder and combiner against beam misalignment in millimeter-wave (mmWave) communication systems. We consider the inclusion of the `error statistics' into the precoder and combiner design,…
Beamforming and precoding/combining are techniques aimed at processing multiantenna signals at the transmitter and/or at the receiver of a wireless communication system. While they have been routinely used to improve performance in current…
This paper proposes an asymptotically optimal hybrid beamforming solution for large antenna arrays by exploiting the properties of the singular vectors of the channel matrix. It is shown that the elements of the channel matrix with Rayleigh…
Recently, intelligent reflecting surface (IRS) and unmanned aerial vehicle (UAV) have been introduced into wireless communication systems to enhance the performance of air-ground transmission. To make a good balance between performance,…
Sub-terahertz (sub-THz) multi-user multiple-input multiple-output (MU-MIMO) systems unlock immense bandwidth for 6G wireless communications. However, practical deployment of wireless systems in sub-THz bands faces critical challenges such…
We propose a deep learning-based method that uses spatial and temporal information extracted from the sub-6GHz band to predict/track beams in the millimeter-wave (mmWave) band. In more detail, we consider a dual-band communication system…
Conventional hybrid beamforming architectures are often compared with one another and with the fully-digital architecture under the same \emph{radiated} antenna power. However, the physically relevant budget is the power injected by the…
It is well-known that the problem of finding the optimal beamformers in massive multiple-input multiple-output (MIMO) networks is challenging because of its non-convexity, and conventional optimization based algorithms suffer from high…