Related papers: Massive MIMO performance with imperfect channel re…
Unlike the time-division duplexing (TDD) systems, the downlink (DL) and uplink (UL) channels are not reciprocal anymore in the case of frequency-division duplexing (FDD). However, some long-term parameters, e.g. the time delays and angles…
Two distinct models of feedback, suited for FDD (Frequency Division Duplex) and TDD (Frequency Division Duplex) systems respectively, have been widely studied in the literature. In this paper, we compare these two models of feedback in…
The acquisition of channel state information (CSI) in Frequency Division Duplex (FDD) massive MIMO has been a formidable challenge. In this paper, we address this problem with a novel CSI feedback framework enabled by the partial…
In this paper, a spatial multiplexing multiple-input multiple-output (MIMO) system when hardware along with RF imperfections occur during the communication setup is analytically investigated. More specifically, the scenario of hardware…
Channel reciprocity can significantly reduce the overhead of obtaining channel-state information at the transmitter (CSIT). However, true reciprocity only exists in time division duplex (TDD). In this paper, we propose a novel tracking…
In time-division duplexing (TDD) systems, massive multiple-input multiple-output (MIMO) relies on the channel reciprocity to obtain the downlink (DL) channel state information (CSI) with the acquired uplink (UL) CSI at the base station…
In this paper, we investigate the energy efficient power allocation for the downlink in the massive multiple-input multiple-output (MIMO) systems under zero-forcing (ZF) receiver. The radio frequencies (RF) that have a significant effect on…
Most communication systems use some form of feedback, often related to channel state information. The common models used in analyses either assume perfect channel state information at the receiver and/or noiseless state feedback links.…
In time division duplexing (TDD) millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems, downlink channel state information (CSI) can be obtained from uplink channel estimation thanks to channel reciprocity. However,…
This paper considers a multi-way massive multiple-input multiple-output relaying system, where single-antenna users exchange their information-bearing signals with the help of one relay station equipped with unconventionally many antennas.…
Relay systems improve both coverage and system capacity. Towards this direction, full-duplex (FD) technology, being able to boost the spectral efficiency by transmitting and receiving simultaneously on the same frequency and time resources,…
In frequency division duplex (FDD) massive multiple-input multiple-output (mMIMO) systems, the reciprocity mismatch caused by receiver distortion seriously degrades the amplitude prediction performance of channel state information (CSI). To…
In this paper, we analyze the asymptotic rate for a multi-carrier (MC) full-duplex (FD) massive multiple input multiple output (mMIMO) decode and forward (DF) relay system which serves multiple MC single-antenna half-duplex (HD) nodes. We…
An essential step for achieving multiplexing gain in MIMO downlink systems is to collect accurate channel state information (CSI) from the users. Traditionally, CSIs have to be collected before any data can be transmitted. Such a sequential…
In frequency-division duplexing (FDD) multiple-input multiple-output (MIMO) systems, obtaining accurate downlink channel state information (CSI) for precoding is vastly challenging due to the tremendous feedback overhead with the growing…
In-band full-duplex transmission allows a relay station to theoretically double its spectral efficiency by simultaneously receiving and transmitting in the same frequency band, when compared to the traditional half-duplex or out-of-band…
In this paper, we propose a novel method for efficient implementation of a massive Multiple-Input Multiple-Output (massive MIMO) system with Frequency Division Duplexing (FDD) operation. Our main objective is to reduce the large overhead…
Massive multiple-input multiple-output (MIMO) enjoys great advantage in 5G wireless communication systems owing to its spectrum and energy efficiency. However, hundreds of antennas require large volumes of pilot overhead to guarantee…
In this work, the joint precoding across two distant transmitters (TXs), sharing the knowledge of the data symbols to be transmitted, to two receivers (RXs), each equipped with one antenna, is discussed. We consider a distributed channel…
Channel estimation and precoding in hybrid analog-digital millimeter-wave (mmWave) MIMO systems is a fundamental problem that has yet to be addressed, before any of the promised gains can be harnessed. For that matter, we propose a method…