Related papers: A Hardware-Efficient Analog Network Structure for …
In this paper we revisit hybrid analog-digital precoding systems with emphasis on their modelling and radio-frequency (RF) losses, to realistically evaluate their benefits in 5G system implementations. For this, we decompose the analog…
Analog/digital hybrid beamforming architectures with large-scale antenna arrays have been widely considered in millimeter wave (mmWave) communication systems because they can address the tradeoff between performance and hardware efficiency…
To keep massive MIMO systems cost-efficient, power amplifiers with rather small output dynamic ranges are employed. They may distort the transmit signal and degrade the performance. This paper proposes a distortion aware precoding scheme…
This paper proposes a novel nature-inspired $\alpha$-fair hybrid precoding (NI-$\alpha$HP) technique for millimeter-wave multi-user massive multiple-input multiple-output systems. Unlike the existing HP literature, we propose to apply…
Millimeter-wave and terahertz technologies have been attracting attention from the wireless research community since they can offer large underutilized bandwidths which can enable the support of ultra-high-speed connections in future…
Aiming at maximizing the achievable sum-rate of wideband multiuser mmWave massive MIMO systems, the hybrid precoding is studied. Since each computation of the achievable sum-rate can be performed only after the analog precoder and digital…
Using precoding to suppress multi-user interference is a well-known technique to improve spectra efficiency in multiuser multiple-input multiple-output (MU-MIMO) systems, and the pursuit of high performance and low complexity precoding…
Energy efficiency has emerged as a critical challenge in modern base stations (BSs), as the power amplifier (PA) consumes a substantial portion of the total power due to its limited efficiency. We investigate waveform and mode adaptation to…
Millimeter-wave (mmWave) MIMO with large antenna array has attracted considerable interests from academic and industry communities, as it can provide larger bandwidth and higher spectrum efficiency. However, with hundreds of antennas, the…
This work proposes a new precoded filter bank (FB) system via a two-dimensional (2D) fast Fourier transform (2D-FFT). Its structure is similar to Orthogonal Time Frequency Space (OTFS) systems, where the OFDM transmitter is changed to a…
Hybrid beamforming (HB) has been widely studied for reducing the number of costly radio frequency (RF) chains in massive multiple-input multiple-output (MIMO) systems. However, previous works on HB are limited to a single user equipment…
Hybrid analog and digital beamforming (HBF) has recently emerged as an attractive technique for millimeter-wave (mmWave) communication systems. It well balances the demand for sufficient beamforming gains to overcome the propagation loss…
This paper proposes a reconfigurable intelligent surface (RIS)-aided and angular-based hybrid beamforming (AB-HBF) technique for the millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems. The proposed RIS-AB-HBF…
We study the multi-user massive multiple-input-single-output (MISO) and focus on the downlink systems where the base station (BS) employs hybrid analog-digital precoding with low-cost 1-bit digital-to-analog converters (DACs). In this…
Conventional hybrid beamforming architectures are often compared with one another and with the fully-digital architecture under the same \emph{radiated} antenna power. However, the physically relevant budget is the power injected by the…
This work jointly addresses user scheduling and precoder/combiner design in the downlink of a wideband millimeter wave (mmWave) communications system. We consider Orthogonal Frequency Division Multiplexing (OFDM) modulation to overcome…
In this paper, the precoding design is investigated for maximizing the throughput of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems with obstructed direct communication paths. In particular, a reconfigurable…
Due to the high cost and low energy efficiency of the dedicated radio frequency (RF) chains, the number of RF chains in a millimeter wave (mmWave) multiple-input multiple-output (MIMO) system is usually limited from a practical point of…
Hybrid analog/digital precoding is a promising technology to cut down hardware cost in massive multi-input multi-output (MIMO) systems at millimeter wave frequencies. In this letter, we propose a joint beam selection scheme for analog…
Hybrid transceiver can strike a balance between complexity and performance of multiple-input multiple-output (MIMO) systems. In this paper, we develop a unified framework on hybrid MIMO transceiver design using matrix-monotonic…