Related papers: Joint Antenna Selection and Phase-Only Beamforming…
In this paper, we propose a novel deep unsupervised learning-based approach that jointly optimizes antenna selection and hybrid beamforming to improve the hardware and spectral efficiencies of massive multiple-input-multiple-output (MIMO)…
This paper considers a lens antenna array-assisted millimeter wave (mmWave) multiuser multiple-input multiple-output (MU-MIMO) system. The base station's beam selection matrix and user terminals' phase-only beamformers are jointly designed…
In this letter, we consider optimal hybrid beamforming design to minimize the transmission power under individual signal-to-interference-plus-noise ratio (SINR) constraints in a multiuser massive multiple-input-multiple-output (MIMO)…
Dynamic metasurface antennas (DMAs) provide a new paradigm to realize large-scale antenna arrays for future wireless systems. In this paper, we study the downlink millimeter wave (mmWave) DMA systems with limited number of radio frequency…
Multicast beamforming is a key technology for next-generation wireless cellular networks to support high-rate content distribution services. In this paper, the coordinated downlink multicast beamforming design in multicell networks is…
Next-generation wireless networks need to handle massive user access effectively. This paper addresses the problem of joint group scheduling and multicast beamforming for downlink transmission with many active user groups. Aiming to…
Beamforming is an effective means to improve the quality of the received signals in multiuser multiple-input-single-output (MISO) systems. Traditionally, finding the optimal beamforming solution relies on iterative algorithms, which…
The joint design of analog beamforming and power allocation is investigated for a single radio-frequency chain multiuser time-division multiple access system under a max-min signal-to-noise ratio (SNR) criterion. A hardware-efficient…
The combination of non-orthogonal multiple access (NOMA) and intelligent reflecting surface (IRS) is an efficient solution to significantly enhance the energy efficiency of the wireless communication system. In this paper, we focus on a…
The design of a set of beamformers for the multiuser multiple-input single-output (MISO) downlink that provides the receivers with prespecified levels of quality-of-service (QoS) can be quite challenging when the channel state information…
In this paper, we consider a multi-cell network where every base station (BS) serves multiple users with an antenna array. Each user is associated with only one BS and has a single antenna. Assume that only long-term channel state…
Detecting weak targets is one of the main challenges for integrated sensing and communication (ISAC) systems. Sensing and communication suffer from a performance trade-off in ISAC systems. As the communication demand increases, sensing…
This paper considers the multi-group multicast beamforming optimization problem, for which the optimal solution has been unknown due to the non-convex and NP-hard nature of the problem. By utilizing the successive convex approximation…
Multibeam technology enables the use of two or more subbeams for joint communication and radio sensing, to meet different requirements of beamwidth and pointing directions. Generating and optimizing multibeam subject to the requirements is…
In millimeter-wave communications, multiple-input-multiple-output (MIMO) systems use large antenna arrays to achieve high gain and spectral efficiency. These massive MIMO systems employ hybrid beamformers to reduce power consumption…
Low-complexity beamformer design with practical constraints is an attractive research area for hybrid analog/digital systems in mm-wave massive multiple-input multiple-output (MIMO). This paper investigates interference-aware pre-beamformer…
This paper considers a reconfigurable intelligent surface (RIS)-aided millimeter wave (mmWave) downlink communication system where hybrid analog-digital beamforming is employed at the base station (BS). We formulate a power minimization…
This work revisits the joint beamforming (BF) and antenna selection (AS) problem, as well as its robust beamforming (RBF) version under imperfect channel state information (CSI). Such problems arise due to various reasons, e.g., the costly…
This paper considers a multicell downlink channel in which multiple base stations (BSs) cooperatively serve users by jointly precoding shared data transported from a central processor over limited-capacity backhaul links. We jointly design…
This paper considers the design of the beamformers for a multiple-input single-output (MISO) downlink system that seeks to mitigate the impact of the imperfections in the channel state information (CSI) that is available at the base station…