Related papers: Characterization of spin coated Zn doped cupric ox…
Spin coating technique was used to synthesize pure ZnO and Cu doped ZnO films on amorphous and conducting glass substrates. The doped amount of Cu in ZnO was varied up to 5% in atomic percentage. Speed of spin coating system, coating time,…
Spin coating technique was employed to fabricate CuO films at different spin speeds for different time duration, and they were annealed at different temperatures for different time durations in air. These thin films were characterized using…
Cu doped transparent ZnO thin films were spin coated on conductive glass substrates. The samples were subsequently annealed in air for 1 hour at 500 0C in order to form the phase of ZnO. ZnO samples were doped with different Cu molar…
Sol-gel spin coating technique was employed to synthesize CuO thin films at 1500 rpm, 2200 rpm and 2400 rpm for 30 seconds, and subsequently annealed at 150-550{\deg}C for 1 hour. Multi-layered CuO thin films with 3 and 5 layers were…
Copper oxide (CuO) thin films have been deposited on glass substrates by a facile sol-gel dip-coating technique with varying withdrawal speeds from 0.73 to 4.17 mm/s. The variation of film thickness manifested by dip-coating withdrawal…
The study uses AACVD technology with nitrogen carrier gas to make AZO thin films through which it determines structural, optical, and morphological changes from 0 to 20 percent aluminum doping. The depositions took place at 400 degrees…
Thin films of ZnO:SnO2 were deposited on different substrates like glass and c-Si using spray pyrolysis method .The structures and morphology of the prepared samples films were cheeked using X-ray diffraction and atomic force microscope.…
Cr-doped ZnO films were fabricated by a new but feasible method, that is, annealing Cr-Zn layers deposited via DC magnetron sputtering in air. Microstructures of the films were investigated using X-ray diffraction, scanning electron…
Thin films of magnesium doped zinc oxide (MZO) were synthesized using the sol gel method and annealed at different temperatures under ambient condition. The morphological properties of the post annealed MZO films were investigated using X…
Among the wide bandgap semiconductors, TiO$_{2}$ is the highly stable and cost-efficient semiconductor used for the different photocatalysis processes like water splitting, chemical waste degradation, anti-micro bacterial activities, and…
The structural, optical, morphological and nonlinear optical properties of Cu:ZnO spray-coated films are studied. The surface morphology of Cu:ZnO thin films turned out to be homogenous, crack free and well covered with pea-shaped grains.…
The problem of detecting the ability of some metal oxides as photocatalysts is receiving considerable attention in the world. The studied zinc oxide is considered as one of the most utilized semiconductors, due to its direct band gap of…
The structural, optical and magnetic properties of the Zn1-xMnxO (0 < x < 0.05) thin films synthesized by sol-gel technique have been analyzed in the light of modification of the electronic structure and disorder developed in the samples…
We have studied the influence of intrinsic and extrinsic defects in the magnetic and electrical transport properties of Co-doped ZnO thin films. X ray absorption measurements show that Co substitute Zn in the ZnO structure and it is in the…
The modification and tailoring the characteristics of nanostructured materials are of great interest due to controllable and unusual inherent properties in such materials. A simple spray pyrolysis technique is used to prepare pure and…
Manganese-doped zinc sulfide nanocrystalline thin films were synthesized using a low-temperature chemical bath deposition and deposited on glass substrates for controlled durations using triethanolamine (TEA) as a complexing and capping…
The Fe-doped CuO thin films were deposited onto glass substrates by Spray pyrolysis technique. The structural, micro-structural, optical and electrical properties of the synthesized samples were investigated in details. The X-Ray…
Thin films of undoped zinc oxide (ZnO) and doped ZnO with copper were deposited on ceramic pellets made from abundant local clay materials with an addition of zirconia (ZrO2). The thin layers were prepared by a thermal method using an…
In the present work, ultrathin films of Zinc oxide (ZnO) and Aluminum doped zinc oxide (AZO) with 20 nm thick were fabricated at 300 K on glass and Polyethylene terephthalate (PET) substrates by means of directcurrent sputtering method. The…
Bacterial infections are a common problem in daily life that can affect human health. Researchers are looking for valuable materials that can help prevent such infections and environmental pollutants. Thin films are a well-known application…