Related papers: Mechanical Stresses Estimation in Silicon and Glas…
The residual stress induced in assembly is a common concern in electronic packaging. The mismatch in coefficient of thermal expansion between borosilicate glass and silicon, upon temperature variation, generates an internal stress state.…
The goal of this work is a scientifically justified choice of efficient technological parameters of anodic bonding of silicon to glass, ensuring a minimum level of residual stresses. The relevance of this dissertation is determined by the…
Stresses caused by thermal expansion coefficients mismatch of anodically bonded glass and silicon samples are studied. An analytical model to determine graphically the optimum bonding temperature is presented. It is essentially a model for…
Simulations are used to examine the microscopic origins of strain hardening in polymer glasses. While stress-strain curves for a wide range of temperature can be fit to the functional form predicted by entropic network models, many other…
Processing results of measurements of linear thermal expansion coefficients and linear thermal expansion of two brands of borosilicate glasses --- LK5 and Borofloat 33 --- are presented. The linear thermal expansion of glass samples have…
Diamond heat-spreaders for gallium nitride (GaN) devices currently depend upon a robust wafer bonding process. Bonding-free membrane methods demonstrate potential, however, chemical vapour deposition (CVD) of diamond directly onto a…
The effect of tensile stress applied during cooling of binary glasses on the potential energy states and mechanical properties is investigated using molecular dynamics simulations. We study the three-dimensional binary mixture that was…
Thin films of superconducting V$_3$Si were prepared by means of RF sputtering from a compound V$_3$Si target at room temperature onto sapphire and oxide-coated silicon wafers, followed by rapid thermal processing under secondary vacuum. The…
An analysis of the dependence of electric potential on the state of stress of a lithiated-silicon electrode is presented. Based on the Larch\'e and Cahn chemical potential for a solid solution, a thermodynamic argument is made for the…
When materials are deformed at extreme strain rates, greater than $10^6 \text{ s}^{-1}$, a counterintuitive mechanical response is seen where the strength and hardness of pure metals increases with increasing temperature. The anti-thermal…
The stress-strain relations and the yield behavior of model glass (a 80:20 binary Lennard-Jones mixture) is studied by means of MD simulations. First, a thorough analysis of the static yield stress is presented via simulations under imposed…
For the construction of the ATLAS Inner Tracker strip detector, silicon strip sensor modules are glued directly onto carbon fibre support structures using a soft silicone gel. During tests at temperatures below \unit[-35]{$^{\circ}$C},…
Much of the progress achieved in understanding plasticity and failure in amorphous solids had been achieved using experiments and simulations in which the materials were loaded using strain control. There is paucity of results under stress…
At low temperature, T -> 0, the yield stress of a perfect crystal is equal to its so called theoretical strength. The yield stress of non-perfect crystals is controlled by the stress threshold of dislocation mobility. A non-crystalline…
We perform molecular dynamics simulations under uniaxial tension to investigate the micromechanisms underlying strain hardening in glassy polymers. By decomposing the stress into virial components associated with pair, bond, and angle…
It is known that 3D-ICs suffer from hot spot temperatures that can reach thousands of degrees, if they are not cooled to reasonable operating temperatures. The problem of hot spots is not limited to the high temperatures of the IC; thermal…
The structural relaxation, potential energy states, and mechanical properties of a model glass subjected to thermal cycling are investigated using molecular dynamics simulations. We study a non-additive binary mixture which is annealed with…
Glasses encode the memory of any thermo-mechanical treatment applied to them. This ability is associated to the existence of a myriad of metastable amorphous states which can be probed through different experimental pathways. It is usually…
Thermal cracking in urban underground sidewalls is frequently observed when structures are cast in summer and enter service in winter, as seasonal temperature gradients act under structural restraint. To quantify the local stress field…
We report in situ measurements of stress evolution in a silicon thin-film electrode during electrochemical lithiation and delithiation by using the Multi-beam Optical Sensor (MOS) technique. Upon lithiation, due to substrate constraint, the…