Related papers: Noncoherent compressive channel estimation for mm-…
Distributed phased arrays based multiple-input multiple-output (DPA-MIMO) is a newly introduced architecture that enables both spatial multiplexing and beamforming while facilitating highly reconfigurable hardware implementation in…
Low overhead channel estimation based on compressive sensing (CS) has been widely investigated for hybrid wideband millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems. The channel sparsifying dictionaries used in prior…
Hybrid analog-digital (HAD) architecture is widely adopted in practical millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems to reduce hardware cost and energy consumption. However, channel estimation in the…
In massive multiple-input multiple-output (MIMO) systems, hybrid analog-digital beamforming is an essential technique for exploiting the potential array gain without using a dedicated radio frequency chain for each antenna. However, due to…
Broadband wireless channel is a time dispersive and becomes strongly frequency selective. In most cases, the channel is composed of a few dominant coefficients and a large part of coefficients is approximately zero or zero. To exploit the…
Exploiting channel sparsity at millimeter wave (mmWave) frequencies reduces the high training overhead associated with the channel estimation stage. Compressive sensing (CS) channel estimation techniques usually adopt the (overcomplete)…
In millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems, one-bit analog-to-digital converters (ADCs) are employed to reduce the impractically high power consumption, which is incurred by the wide bandwidth and…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
We consider the problem of downlink channel estimation for millimeter wave (mmWave) MIMO-OFDM systems, where both the base station (BS) and the mobile station (MS) employ large antenna arrays for directional precoding/beamforming. Hybrid…
Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) with hybrid precoding is a promising technique for the future 5G wireless communications. Due to a large number of antennas but a much smaller number of radio frequency…
Massive MIMO communication systems, by virtue of utilizing very large number of antennas, have a potential to yield higher spectral and energy efficiency in comparison with the conventional MIMO systems. In this paper, we consider uplink…
This thesis considers channel estimation and multiuser (MU) data transmission for massive MIMO systems with fully digital/hybrid structures in mmWave channels. It contains three main contributions. In this thesis, we first propose a…
Millimeter wave (mmWave) multiple-input-multi-output (MIMO) is now a reality with great potential for further improvement. We study full-duplex transmissions as an effective way to improve mmWave MIMO systems. Compared to half-duplex…
In massive multiple-input multiple-output (MIMO) systems, the channel estimation scheme is subject to the spatial non-stationarity and inevitably power leakage in the beam domain. In this paper, a beam domain channel estimation scheme is…
Millimeter wave MIMO combines the benefits of compact antenna arrays with a large number of elements and massive bandwidths, so that fully digital beamforming has the potential of supporting a large number of simultaneous users with {\it…
In this paper we present a measurement set-up for massive MIMO channel sounding that shows very good long-term phase stability. Initial measurements were performed in a residential area to evaluate different conventional precoding schemes…
Multi-frequency massive multi-input multi-output (MIMO) communication is a promising strategy for both 5G and future 6G systems, ensuring reliable transmission while enhancing frequency resource utilization. Statistical channel state…
Millimeter wave (mmWave) cellular systems will enable gigabit-per-second data rates thanks to the large bandwidth available at mmWave frequencies. To realize sufficient link margin, mmWave systems will employ directional beamforming with…
With the goal of enabling ultrareliable and low-latency wireless communications for industrial internet of things (IIoT), this paper studies the use of energy-based modulations in noncoherent massive single-input multiple-output (SIMO)…
In this letter, we consider the problem of channel estimation for large intelligent metasurface (LIM) assisted massive multiple-input multiple-output (MIMO) systems. The main challenge of this problem is that the LIM integrated with a large…