Related papers: Pilot Contamination Mitigation with Reduced RF Cha…
This paper considers the physical layer security of a pilot-based massive multiple-input multiple-output (MaMIMO) system in presence of a multi-antenna jammer. To improve security of the network, we propose a new jamming detection method…
Massive multiple-input multiple-output (MIMO) can improve the overall system performance significantly. Massive MIMO systems, however, may require a large number of radio frequency (RF) chains that could cause high cost and power…
In this paper, we study a new kind of pilot contamination appearing in multi-operator reconfigurable intelligent surfaces (RIS) assisted networks, where multiple operators provide services to their respective served users. The operators use…
Hybrid analog-digital precoding significantly reduces the hardware costs in massive MIMO transceivers when compared to fully-digital precoding at the expense of increased transmit power. In order to mitigate the above shortfall, we use the…
The capacity of a discrete-time multi-input multi-output (MIMO) Gaussian channel with output quantization is investigated for different receiver architectures. A general formulation of this problem is proposed in which the antenna outputs…
Millimeter wave (mmWave) massive MIMO can achieve orders of magnitude increase in spectral and energy efficiency, and it usually exploits the hybrid analog and digital precoding to overcome the serious signal attenuation induced by mmWave…
Multiuser beamforming is considered for partially-connected millimeter wave massive MIMO systems. Based on perfect channel state information (CSI), a low-complexity hybrid beamforming scheme that decouples the analog beamformer and the…
In this paper, we aim to achieve energy efficient design with minimum hardware requirement for hybrid precoding, which enables a large number of antennas with minimal number of RF chains, and sub-arrayed multiple-input multiple-output…
The hybrid analog/digital architecture that connects a limited number of RF chains to multiple antennas through phase shifters could effectively address the energy consumption issues in massive multiple-input multiple-output (MIMO) systems.…
Network densification, massive multiple-input multiple-output (MIMO) and millimeter-wave (mmWave) bands have recently emerged as some of the physical layer enablers for the future generations of wireless communication networks (5G and…
Base stations with a large number of transmit antennas have the potential to serve a large number of users simultaneously at higher rates. They also promise a lower power consumption due to coherent combining at the receiver. However, the…
Hybrid analog/digital architectures and receivers with low-resolution analog-to-digital converters (ADCs) are two low power solutions for wireless systems with large antenna arrays. Most prior work represents two extreme cases in which…
This paper investigates the linear precoder design for $K$-user interference channels of multiple-input multiple-output (MIMO) transceivers under finite alphabet inputs. We first obtain general explicit expressions of the achievable rate…
Accurate channel state information in wideband multiple-input multiple-output (MIMO) systems is fundamentally constrained by pilot overhead, a challenge that intensifies as antenna counts and bandwidths scale toward 6G. This paper proposes…
In this paper, we investigate the downlink throughput performance of a massive multiple-input multiple-output (MIMO) system that employs superimposed pilots for channel estimation. The component of downlink (DL) interference that results…
The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…
We consider a massive MIMO system based on Time Division Duplexing (TDD) and channel reciprocity, where the base stations (BSs) learn the channel vectors of their users via the pilots transmitted by the users in the uplink (UL). It is…
Increasing the number of transmit and receive elements in multiple-input-multiple-output (MIMO) antenna arrays imposes a substantial increase in hardware and computational costs. We mitigate this problem by employing a reconfigurable MIMO…
This paper presents a generalized closed-form beamforming technique that can achieve the maximum degrees of freedom in compounded multiple-input multiple-output (MIMO) broadcast channels with mixed classes of multiple-antenna users. The…
Multi-antenna precoding effectively mitigates the interference in wireless networks. However, the precoding efficiency can be significantly degraded by the overhead due to the required feedback of channel state information (CSI). This paper…